Mayville Engineering Co Inc stock PB Ratio (=3) is close to 10-year high of 3.14.
The historical rank and industry rank for Mayville Engineering Co's PB Ratio or its related term are showing as below:
FRA:2YN'
s PB Ratio Range Over the Past 10 Years
Min: 0.49 Med: 1.19 Max: 3.14
Current: 2.98
During the past 9 years, Mayville Engineering Co's highest PB Ratio was 3.14. The lowest was 0.49. And the median was 1.19.
FRA:2YN's PB Ratio is ranked worse than 60.88% of 2986
companies
in the Industrial Products industry
Industry Median: 2.32
vs FRA:2YN: 2.98
During the past 12 months, Mayville Engineering Co's average Book Value Per Share Growth Rate was -7.10% per year.
During the past 3 years, the average Book Value Per Share Growth Rate was 3.10% per year.
During the past 5 years, the average Book Value Per Share Growth Rate was 5.30% per year.
During the past 9 years, the highest 3-Year average Book Value Per Share Growth Rate of Mayville Engineering Co was 28.50% per year. The lowest was 1.80% per year. And the median was 10.15% per year.
Back to Basics: PB Ratio
Mayville Engineering Co (FRA:2YN) PB Ratio Explanation
The PB Ratio works the best for the businesses that earn most of their profit from their assets, e.g. banks and insurance companies.
Be Aware
Some businesses have very light assets, such as software companies or insurance agencies. The PB Ratio does not work well for these companies. Some companies even have negative equity, so the PB Ratio cannot be applied to them.
* For Operating Data section: All numbers are indicated by the unit behind each term and all currency related amount are in USD. * For other sections: All numbers are in millions except for per share data, ratio, and percentage. All currency related amount are indicated in the company's associated stock exchange currency.
For the Metal Fabrication subindustry, Mayville Engineering Co's PB Ratio, along with its competitors' market caps and PB Ratio data, can be viewed below:
* Competitive companies are chosen from companies within the same industry, with headquarter located in same country, with closest market capitalization; x-axis shows the market cap, and y-axis shows the term value; the bigger the dot, the larger the market cap. Note that "N/A" values will not show up in the chart.
Mayville Engineering Co PB Ratio vs Industrial Products Industry
For the Industrial Products industry and Industrials sector, Mayville Engineering Co's PB Ratio distribution charts can be found below:
* The bar in red indicates where Mayville Engineering Co's PB Ratio falls into.
The PB Ratio, or Price-to-Book ratio, or Price/Book, is a financial ratio used to compare a company's market price to its Book Value per Share. It is a ratio widely used to value stocks.
* For Operating Data section: All numbers are indicated by the unit behind each term and all currency related amount are in USD. * For other sections: All numbers are in millions except for per share data, ratio, and percentage. All currency related amount are indicated in the company's associated stock exchange currency.
It can also be calculated from the numbers for the whole company:
A closely related ratio is called Price-to-Tangible-Book. The difference between Price-to-Tangible-Book and PB Ratio is that book value other than intangibles are used in the calculation.
Mayville Engineering Co (FRA:2YN) has a PB Ratio of 3.01 as of Jun. 25, 2026. Price-to-Book ratio is the ratio of share price to a company's book value per share. View historical data on Mayville Engineering Co and its competitors. This is 153% above median its historical median of 1.19. Over the past decade, Mayville Engineering Co's PB Ratio has ranged from 0.49 to 3.14. According to the industry distribution chart, Mayville Engineering Co ranks #1818 out of 2986 companies in the Industrial Products industry, placing it in the top 60.9%.
Is Mayville Engineering Co's PB Ratio too high?
Mayville Engineering Co's current PB Ratio of 3.01 is 153% above median its 10-year median of 1.19. Over the past 10 years, this metric has ranged from a low of 0.49 to a high of 3.14. The Industrial Products industry median PB Ratio is 2.32. Mayville Engineering Co's value of 3.01 is 29.7% above this industry median. Based on the distribution chart, Mayville Engineering Co ranks #1818 out of 2986 companies in the Industrial Products industry, which is below the industry midpoint. Overall, Mayville Engineering Co has a GF Score™ of 67/100, reflecting its overall financial health beyond just this single metric.
How does Mayville Engineering Co's PB Ratio compare to IIIN and TG?
According to the Industrial Products industry distribution chart, Mayville Engineering Co ranks #1818 out of 2986 companies for PB Ratio. This places Mayville Engineering Co in the lower half of its industry. The industry median PB Ratio is 2.32. Mayville Engineering Co's value of 3.01 is 29.7% above this benchmark. Historically, Mayville Engineering Co's own PB Ratio has ranged from 0.49 to 3.14 over the past decade. While the company's 10-year median is 1.19 vs. the industry median of 2.32, Mayville Engineering Co has consistently been above the industry average. See the competitive comparison table and distribution chart on this page for a detailed peer-by-peer breakdown.
What is a good PB Ratio for an Industrial Products company?
The median PB Ratio among Industrial Products companies is 2.32, based on 2,986 companies in the industry. Companies in the top quartile (top 25%) have a PB Ratio significantly above this median, while those in the bottom quartile fall well below. However, PB Ratio should not be evaluated in isolation — investors should consider it alongside profitability, growth, and financial strength metrics. Mayville Engineering Co's current PB Ratio of 3.01 is 29.7% above the industry median. Use the industry distribution chart on this page to see where any company falls relative to its peers.
What does a high PB Ratio mean?
A high PB Ratio can signal that a stock is expensive relative to its fundamentals. Price-to-Book ratio is the ratio of share price to a company's book value per share. View historical data on Mayville Engineering Co and its competitors. For the Industrial Products industry, the median PB Ratio is 2.32 — values significantly above this may indicate overvaluation, while values below may suggest a bargain or underlying issues. Mayville Engineering Co's current PB Ratio is 3.01, which is 153% above median its own 10-year median of 1.19. However, context matters — high-growth companies often justify higher valuations. Always evaluate alongside other metrics like GF Score™ and GF Value™.
Is Mayville Engineering Co stock overvalued right now?
Mayville Engineering Co (FRA:2YN) has a current PB Ratio of 3.01. The stock's GF Value™ is €13.46, compared to a current price of €29.60 — trading 119.9% above its estimated fair value. The current PB Ratio is 3.01, which is 153% above median its 10-year median of 1.19 and 29.7% above the Industrial Products industry median of 2.32. Mayville Engineering Co's overall GF Score™ is 67/100 with 7 warning signs to review. Investors should evaluate multiple metrics — including profitability, growth, and financial strength — before making a decision.
How is PB Ratio calculated?
PB Ratio is calculated from a company's financial statements. For Mayville Engineering Co (FRA:2YN), the current PB Ratio is 3.01 as of Jun. 25, 2026. GuruFocus calculates this using data sourced from SEC filings and annual reports. See the calculation section and 30-year financial data on this page for the full breakdown.
Is Mayville Engineering Co (FRA:2YN) Overvalued in 2026?
Based on GuruFocus' analysis, Mayville Engineering Co stock appears to be overvalued.
The current stock price of €29.60 is trading 119.9% above its estimated GF Value™ of €13.46.
Key valuation signals for FRA:2YN:
PB Ratio: 3.01 (153% above median its 10-year median of 1.19)
GF Value™: €13.46 vs. price of €29.60 (119.9% above fair value)
Industry Position: 29.7% above the Industrial Products median (#1818 of 2986)
No single metric tells the full story. See the FRA:2YN stock analysis page for a complete view including 30-year financials, guru trades, and insider activity.
Mayville Engineering Co Inc is involved in a manufacturing partner providing a full suite of manufacturing solutions from concept to production, including design, prototyping and tooling, fabrication, aluminum extrusion, coating, assembly, and aftermarket components. Its customers operate in diverse end markets, including heavy- and medium-duty commercial vehicles, construction, powersports, agriculture, military, and other end markets. Its services comprise stamping, shearing, fiber laser cutting, forming, drilling, tapping, grinding, tube bending, machining, welding, assembly, and logistic services.
67GF Score
Get the complete analysis for FRA:2YN
PB Ratio is just one metric. See GF Value™, 30-year financials, guru trades, warning signs, and more.
Quick Browse
Personalize
Premium Gurus 
Create New Portfolio
FRA:2YN has been successfully added to your 
