Focused on building reliable datasets, financial models, and research tools for value-minded investors. Committed to turning complex data into practical guidance for value-investing and long-term wealth.
Dr. Charlie Tian is the founder and CEO of GuruFocus.com, a leading global investment research platform established in 2004. With a Ph.D. in physics, Dr. Tian transitioned from science to finance, applying a data-driven, disciplined approach to value investing.
Da Ming International Holdings (FRA:DM7) Equity-to-Asset Explanation
Equity to Asset ratio can vary greatly across different industries, as they have different capital structure. A company with smaller Equity to Asset ratio (more leveraged) may have higher ROE % because of the leverage.
For banks, the required minimum Equity to Asset ratio by regulation is 5%. Some stronger banks may have Equity to Asset Ratio of more than 10%.
Da Ming International Holdings Equity-to-Asset Related Terms
Da Ming International Holdings Equity-to-Asset Historical Data
* For Operating Data section: All numbers are indicated by the unit behind each term and all currency related amount are in USD. * For other sections: All numbers are in millions except for per share data, ratio, and percentage. All currency related amount are indicated in the company's associated stock exchange currency.
Da Ming International Holdings Equity-to-Asset Chart
FRA:DM7 vs NUE, STLD, RS: Equity-to-Asset Comparison
For the Steel subindustry, Da Ming International Holdings's Equity-to-Asset, along with its competitors' market caps and Equity-to-Asset data, can be viewed below:
* Competitive companies are chosen from companies within the same industry, with headquarter located in same country, with closest market capitalization; x-axis shows the market cap, and y-axis shows the term value; the bigger the dot, the larger the market cap. Note that "N/A" values will not show up in the chart.
Da Ming International Holdings Equity-to-Asset vs Steel Industry
For the Steel industry and Basic Materials sector, Da Ming International Holdings's Equity-to-Asset distribution charts can be found below:
* The bar in red indicates where Da Ming International Holdings's Equity-to-Asset falls into.
Da Ming International Holdings Equity-to-Asset Calculation
Equity to Asset ratio measures the ratios of the portion of the asset owned by shareholders out of the total asset. It indicates the leverage of the company, and the amount of debt the company uses in its operation.
Equity to Asset ratio is calculated by dividing total stockholders equity by total asset.
* For Operating Data section: All numbers are indicated by the unit behind each term and all currency related amount are in USD. * For other sections: All numbers are in millions except for per share data, ratio, and percentage. All currency related amount are indicated in the company's associated stock exchange currency.
Da Ming International Holdings (FRA:DM7) has a Equity-to-Asset of 0.20 as of Dec. 2025. Equity-to-asset ratio equals total company equity divided by total assets. It measures financial leverage. View historical data on Da Ming International Holdings and its competitors. This is 20% below median its historical median of 0.25. Over the past decade, Da Ming International Holdings' Equity-to-Asset has ranged from 0.20 to 0.29. According to the industry distribution chart, Da Ming International Holdings ranks #581 out of 634 companies in the Steel industry, placing it in the top 91.6%.
Is Da Ming International Holdings' Equity-to-Asset too high?
Da Ming International Holdings' current Equity-to-Asset of 0.20 is 20% below median its 10-year median of 0.25. Over the past 10 years, this metric has ranged from a low of 0.20 to a high of 0.29. The Steel industry median Equity-to-Asset is 0.54. Da Ming International Holdings' value of 0.20 is 63% below this industry median. Based on the distribution chart, Da Ming International Holdings ranks #581 out of 634 companies in the Steel industry, which is in the bottom quartile relative to peers. Overall, Da Ming International Holdings has a GF Score™ of 36/100, reflecting its overall financial health beyond just this single metric.
How does Da Ming International Holdings' Equity-to-Asset compare to NUE and STLD?
According to the Steel industry distribution chart, Da Ming International Holdings ranks #581 out of 634 companies for Equity-to-Asset. This places Da Ming International Holdings in the lower half of its industry. The industry median Equity-to-Asset is 0.54. Da Ming International Holdings' value of 0.20 is 63% below this benchmark. Historically, Da Ming International Holdings' own Equity-to-Asset has ranged from 0.20 to 0.29 over the past decade. While the company's 10-year median is 0.25 vs. the industry median of 0.54, Da Ming International Holdings has consistently been below the industry average. See the competitive comparison table and distribution chart on this page for a detailed peer-by-peer breakdown.
What is a good Equity-to-Asset for a Steel company?
The median Equity-to-Asset among Steel companies is 0.54, based on 634 companies in the industry. Companies in the top quartile (top 25%) have a Equity-to-Asset significantly above this median, while those in the bottom quartile fall well below. However, Equity-to-Asset should not be evaluated in isolation — investors should consider it alongside profitability, growth, and financial strength metrics. Da Ming International Holdings's current Equity-to-Asset of 0.20 is 63% below the industry median. Use the industry distribution chart on this page to see where any company falls relative to its peers.
What does a high Equity-to-Asset mean?
A high Equity-to-Asset can signal that a stock is expensive relative to its fundamentals. Equity-to-asset ratio equals total company equity divided by total assets. It measures financial leverage. View historical data on Da Ming International Holdings and its competitors. For the Steel industry, the median Equity-to-Asset is 0.54 — values significantly above this may indicate overvaluation, while values below may suggest a bargain or underlying issues. Da Ming International Holdings's current Equity-to-Asset is 0.20, which is 20% below median its own 10-year median of 0.25. However, context matters — high-growth companies often justify higher valuations. Always evaluate alongside other metrics like GF Score™ and GF Value™.
Is Da Ming International Holdings stock overvalued right now?
Da Ming International Holdings (FRA:DM7) has a current Equity-to-Asset of 0.20. The stock's GF Value™ is €0.07, compared to a current price of €0.05 — trading 26.4% below its estimated fair value. The current Equity-to-Asset is 0.20, which is 20% below median its 10-year median of 0.25 and 63% below the Steel industry median of 0.54. Da Ming International Holdings' overall GF Score™ is 36/100 with 6 warning signs to review. Investors should evaluate multiple metrics — including profitability, growth, and financial strength — before making a decision.
How is Equity-to-Asset calculated?
Equity-to-Asset is calculated from a company's financial statements. For Da Ming International Holdings (FRA:DM7), the current Equity-to-Asset is 0.20 as of Dec. 2025. GuruFocus calculates this using data sourced from SEC filings and annual reports. See the calculation section and 30-year financial data on this page for the full breakdown.
Is Da Ming International Holdings (FRA:DM7) Overvalued in 2026?
Based on GuruFocus' analysis, Da Ming International Holdings stock appears to be undervalued.
The current stock price of €0.05 is trading 26.4% below its estimated GF Value™ of €0.07.
Key valuation signals for FRA:DM7:
Equity-to-Asset: 0.20 (20% below median its 10-year median of 0.25)
GF Value™: €0.07 vs. price of €0.05 (26.4% below fair value)
Industry Position: 63% below the Steel median (#581 of 634)
No single metric tells the full story. See the FRA:DM7 stock analysis page for a complete view including 30-year financials, guru trades, and insider activity.
Da Ming International Holdings Ltd is engaged in the processing, distribution, and sale of stainless steel and carbon steel products. The reportable operating segments of the company are: Processing, which derives key revenue and includes processing of stainless steel and carbon steel products and components, and equipment; and the Manufacturing segment, which involves manufacturing of equipment and mechanical parts. Geographically, the company generates the majority of its revenue from its customers in the People's Republic of China (PRC).
36GF Score
Get the complete analysis for FRA:DM7
Equity-to-Asset is just one metric. See GF Value™, 30-year financials, guru trades, warning signs, and more.
Quick Browse
Personalize
Premium Gurus 
Create New Portfolio
FRA:DM7 has been successfully added to your 
