Feng Hsin Steel Co Ltd stock PB Ratio (=1.55) is close to 10-year low of 1.44.
The historical rank and industry rank for Feng Hsin Steel Co's PB Ratio or its related term are showing as below:
TPE:2015'
s PB Ratio Range Over the Past 10 Years
Min: 1.44 Med: 1.85 Max: 2.79
Current: 1.59
During the past 13 years, Feng Hsin Steel Co's highest PB Ratio was 2.79. The lowest was 1.44. And the median was 1.85.
TPE:2015's PB Ratio is ranked worse than 70.28% of 609
companies
in the Steel industry
Industry Median: 0.96
vs TPE:2015: 1.59
During the past 12 months, Feng Hsin Steel Co's average Book Value Per Share Growth Rate was 1.50% per year.
During the past 3 years, the average Book Value Per Share Growth Rate was 1.20% per year.
During the past 5 years, the average Book Value Per Share Growth Rate was 2.20% per year.
During the past 10 years, the average Book Value Per Share Growth Rate was 3.70% per year.
During the past 13 years, the highest 3-Year average Book Value Per Share Growth Rate of Feng Hsin Steel Co was 6.00% per year. The lowest was -1.30% per year. And the median was 3.40% per year.
Back to Basics: PB Ratio
Feng Hsin Steel Co (TPE:2015) PB Ratio Explanation
The PB Ratio works the best for the businesses that earn most of their profit from their assets, e.g. banks and insurance companies.
Be Aware
Some businesses have very light assets, such as software companies or insurance agencies. The PB Ratio does not work well for these companies. Some companies even have negative equity, so the PB Ratio cannot be applied to them.
Feng Hsin Steel Co PB Ratio Related Terms
Feng Hsin Steel Co PB Ratio Historical Data
* Premium members only.
The historical data trend for Feng Hsin Steel Co's PB Ratio can be seen below:
* For Operating Data section: All numbers are indicated by the unit behind each term and all currency related amount are in USD. * For other sections: All numbers are in millions except for per share data, ratio, and percentage. All currency related amount are indicated in the company's associated stock exchange currency.
For the Steel subindustry, Feng Hsin Steel Co's PB Ratio, along with its competitors' market caps and PB Ratio data, can be viewed below:
* Competitive companies are chosen from companies within the same industry, with headquarter located in same country, with closest market capitalization; x-axis shows the market cap, and y-axis shows the term value; the bigger the dot, the larger the market cap. Note that "N/A" values will not show up in the chart.
Feng Hsin Steel Co PB Ratio vs Steel Industry
For the Steel industry and Basic Materials sector, Feng Hsin Steel Co's PB Ratio distribution charts can be found below:
* The bar in red indicates where Feng Hsin Steel Co's PB Ratio falls into.
The PB Ratio, or Price-to-Book ratio, or Price/Book, is a financial ratio used to compare a company's market price to its Book Value per Share. It is a ratio widely used to value stocks.
* For Operating Data section: All numbers are indicated by the unit behind each term and all currency related amount are in USD. * For other sections: All numbers are in millions except for per share data, ratio, and percentage. All currency related amount are indicated in the company's associated stock exchange currency.
It can also be calculated from the numbers for the whole company:
A closely related ratio is called Price-to-Tangible-Book. The difference between Price-to-Tangible-Book and PB Ratio is that book value other than intangibles are used in the calculation.
Feng Hsin Steel Co (TPE:2015) has a PB Ratio of 1.59 as of Jul. 02, 2026. Price-to-Book ratio is the ratio of share price to a company's book value per share. View historical data on Feng Hsin Steel Co and its competitors. This is 14% below median its historical median of 1.85. Over the past decade, Feng Hsin Steel Co's PB Ratio has ranged from 1.44 to 2.79. According to the industry distribution chart, Feng Hsin Steel Co ranks #428 out of 609 companies in the Steel industry, placing it in the top 70.3%.
Is Feng Hsin Steel Co's PB Ratio too high?
Feng Hsin Steel Co's current PB Ratio of 1.59 is 14% below median its 10-year median of 1.85. Over the past 10 years, this metric has ranged from a low of 1.44 to a high of 2.79. The Steel industry median PB Ratio is 0.96. Feng Hsin Steel Co's value of 1.59 is 65.6% above this industry median. Based on the distribution chart, Feng Hsin Steel Co ranks #428 out of 609 companies in the Steel industry, which is below the industry midpoint. Overall, Feng Hsin Steel Co has a GF Score™ of 79/100 and is considered Fairly Valued, reflecting its overall financial health beyond just this single metric.
How does Feng Hsin Steel Co's PB Ratio compare to NUE and STLD?
According to the Steel industry distribution chart, Feng Hsin Steel Co ranks #428 out of 609 companies for PB Ratio. This places Feng Hsin Steel Co in the lower half of its industry. The industry median PB Ratio is 0.96. Feng Hsin Steel Co's value of 1.59 is 65.6% above this benchmark. Historically, Feng Hsin Steel Co's own PB Ratio has ranged from 1.44 to 2.79 over the past decade. While the company's 10-year median is 1.85 vs. the industry median of 0.96, Feng Hsin Steel Co has consistently been above the industry average. See the competitive comparison table and distribution chart on this page for a detailed peer-by-peer breakdown.
What is a good PB Ratio for a Steel company?
The median PB Ratio among Steel companies is 0.96, based on 609 companies in the industry. Companies in the top quartile (top 25%) have a PB Ratio significantly above this median, while those in the bottom quartile fall well below. However, PB Ratio should not be evaluated in isolation — investors should consider it alongside profitability, growth, and financial strength metrics. Feng Hsin Steel Co's current PB Ratio of 1.59 is 65.6% above the industry median. Use the industry distribution chart on this page to see where any company falls relative to its peers.
What does a high PB Ratio mean?
A high PB Ratio can signal that a stock is expensive relative to its fundamentals. Price-to-Book ratio is the ratio of share price to a company's book value per share. View historical data on Feng Hsin Steel Co and its competitors. For the Steel industry, the median PB Ratio is 0.96 — values significantly above this may indicate overvaluation, while values below may suggest a bargain or underlying issues. Feng Hsin Steel Co's current PB Ratio is 1.59, which is 14% below median its own 10-year median of 1.85. However, context matters — high-growth companies often justify higher valuations. Always evaluate alongside other metrics like GF Score™ and GF Value™.
Is Feng Hsin Steel Co stock overvalued right now?
Based on GuruFocus' analysis, Feng Hsin Steel Co (TPE:2015) is currently considered Fairly Valued. The stock's GF Value™ is NT$56.70, compared to a current price of NT$61.70 — trading 8.8% above its estimated fair value. The current PB Ratio is 1.59, which is 14% below median its 10-year median of 1.85 and 65.6% above the Steel industry median of 0.96. Feng Hsin Steel Co's overall GF Score™ is 79/100 with 4 warning signs to review. Investors should evaluate multiple metrics — including profitability, growth, and financial strength — before making a decision.
How is PB Ratio calculated?
PB Ratio is calculated from a company's financial statements. For Feng Hsin Steel Co (TPE:2015), the current PB Ratio is 1.59 as of Jul. 02, 2026. GuruFocus calculates this using data sourced from SEC filings and annual reports. See the calculation section and 30-year financial data on this page for the full breakdown.
Is Feng Hsin Steel Co (TPE:2015) Overvalued in 2026?
Based on GuruFocus' analysis, Feng Hsin Steel Co stock appears to be overvalued.
The current stock price of NT$61.70 is trading 8.8% above its estimated GF Value™ of NT$56.70.
GuruFocus considers Feng Hsin Steel Co to be Fairly Valued.
Key valuation signals for TPE:2015:
PB Ratio: 1.59 (14% below median its 10-year median of 1.85)
GF Value™: NT$56.70 vs. price of NT$61.70 (8.8% above fair value)
Industry Position: 65.6% above the Steel median (#428 of 609)
No single metric tells the full story. See the TPE:2015 stock analysis page for a complete view including 30-year financials, guru trades, and insider activity.
Feng Hsin Steel Co Ltd manufacture and sell various types of steel products. The services provided by the Group mainly consist of transportation and insurance services for the various steel products sold. The company is engaged in the manufacturing, processing and trading of various angle iron, round iron, flat iron, flat bar, and others, along with the operation and investment of various incidental businesses. Its Steel Rolling Mill produces carbon steel and special steel. Geographically, the company generates maximum revenue from Taiwan.
79GF Score
Get the complete analysis for TPE:2015
PB Ratio is just one metric. See GF Value™, 30-year financials, guru trades, warning signs, and more.
Quick Browse
Personalize
Premium Gurus 
Create New Portfolio
TPE:2015 has been successfully added to your 
