* The 5-Year EBITDA Growth Rate is the 5-year average EBITDA per share growth rate. While the denominator is a percentage, we use the whole number as opposed to the decimal form for the calculation. For example, 5% would be shown as 5 as opposed to 0.05. If it's smaller than or equal to 0, then the PEG Ratio is not calculated.
The historical rank and industry rank for Standard Motor Products's PEG Ratio or its related term are showing as below:
FRA:SRU'
s PEG Ratio Range Over the Past 10 Years
Min: 0.87 Med: 3.04 Max: 35.03
Current: 4.65
During the past 13 years, Standard Motor Products's highest PEG Ratio was 35.03. The lowest was 0.87. And the median was 3.04.
FRA:SRU's PEG Ratio is ranked worse than 82.69% of 670
companies
in the Vehicles & Parts industry
Industry Median: 1.13
vs FRA:SRU: 4.65
Peter Lynch thinks a company with a P/E ratio equal to its growth rate is fairly valued.
Standard Motor Products (FRA:SRU) PEG Ratio Explanation
To compare stocks with different growth rates, Peter Lynch invented a ratio called PEG Ratio. PEG Ratio is defined as the P/E ratio divided by the growth ratio. He thinks a company with a P/E ratio equal to its growth rate is fairly valued. Still he said he would rather buy a company growing 20% a year with a P/E of 20, instead of a company growing 10% a year with a P/E of 10.
* For Operating Data section: All numbers are indicated by the unit behind each term and all currency related amount are in USD. * For other sections: All numbers are in millions except for per share data, ratio, and percentage. All currency related amount are indicated in the company's associated stock exchange currency.
For the Auto Parts subindustry, Standard Motor Products's PEG Ratio, along with its competitors' market caps and PEG Ratio data, can be viewed below:
* Competitive companies are chosen from companies within the same industry, with headquarter located in same country, with closest market capitalization; x-axis shows the market cap, and y-axis shows the term value; the bigger the dot, the larger the market cap. Note that "N/A" values will not show up in the chart.
Standard Motor Products PEG Ratio vs Vehicles & Parts Industry
For the Vehicles & Parts industry and Consumer Cyclical sector, Standard Motor Products's PEG Ratio distribution charts can be found below:
* The bar in red indicates where Standard Motor Products's PEG Ratio falls into.
* For Operating Data section: All numbers are indicated by the unit behind each term and all currency related amount are in USD. * For other sections: All numbers are in millions except for per share data, ratio, and percentage. All currency related amount are indicated in the company's associated stock exchange currency.
* Note: The 5-Year EBITDA Growth Rate is the 5-year average EBITDA per share growth rate. While the denominator is a percentage, we use the whole number as opposed to the decimal form for the calculation. For example, 5% would be shown as 5 as opposed to 0.05. If it's smaller than or equal to 0, then the PEG Ratio is not calculated.
Standard Motor Products (FRA:SRU) has a PEG Ratio of 4.65 as of Jul. 11, 2026. Price-earnings to growth ratio is the ratio of price-earnings to a company's earnings growth rate. View historical data on Standard Motor Products and its competitors. This is 53% above median its historical median of 3.04. Over the past decade, Standard Motor Products' PEG Ratio has ranged from 0.87 to 35.03. According to the industry distribution chart, Standard Motor Products ranks #554 out of 670 companies in the Vehicles & Parts industry, placing it in the top 82.7%.
Is Standard Motor Products' PEG Ratio too high?
Standard Motor Products' current PEG Ratio of 4.65 is 53% above median its 10-year median of 3.04. Over the past 10 years, this metric has ranged from a low of 0.87 to a high of 35.03. The Vehicles & Parts industry median PEG Ratio is 1.13. Standard Motor Products' value of 4.65 is 311.5% above this industry median. Based on the distribution chart, Standard Motor Products ranks #554 out of 670 companies in the Vehicles & Parts industry, which is in the bottom quartile relative to peers. Overall, Standard Motor Products has a GF Score™ of 85/100, reflecting its overall financial health beyond just this single metric.
How does Standard Motor Products' PEG Ratio compare to FOXF and HYLN?
According to the Vehicles & Parts industry distribution chart, Standard Motor Products ranks #554 out of 670 companies for PEG Ratio. This places Standard Motor Products in the lower half of its industry. The industry median PEG Ratio is 1.13. Standard Motor Products' value of 4.65 is 311.5% above this benchmark. Historically, Standard Motor Products' own PEG Ratio has ranged from 0.87 to 35.03 over the past decade. While the company's 10-year median is 3.04 vs. the industry median of 1.13, Standard Motor Products has consistently been above the industry average. See the competitive comparison table and distribution chart on this page for a detailed peer-by-peer breakdown.
What is a good PEG Ratio for a Vehicles & Parts company?
The median PEG Ratio among Vehicles & Parts companies is 1.13, based on 670 companies in the industry. Companies in the top quartile (top 25%) have a PEG Ratio significantly above this median, while those in the bottom quartile fall well below. However, PEG Ratio should not be evaluated in isolation — investors should consider it alongside profitability, growth, and financial strength metrics. Standard Motor Products's current PEG Ratio of 4.65 is 311.5% above the industry median. Use the industry distribution chart on this page to see where any company falls relative to its peers.
What does a high PEG Ratio mean?
A high PEG Ratio can signal that a stock is expensive relative to its fundamentals. Price-earnings to growth ratio is the ratio of price-earnings to a company's earnings growth rate. View historical data on Standard Motor Products and its competitors. For the Vehicles & Parts industry, the median PEG Ratio is 1.13 — values significantly above this may indicate overvaluation, while values below may suggest a bargain or underlying issues. Standard Motor Products's current PEG Ratio is 4.65, which is 53% above median its own 10-year median of 3.04. However, context matters — high-growth companies often justify higher valuations. Always evaluate alongside other metrics like GF Score™ and GF Value™.
Is Standard Motor Products stock overvalued right now?
Standard Motor Products (FRA:SRU) has a current PEG Ratio of 4.65. The stock's GF Value™ is €35.86, compared to a current price of €32.20 — trading 10.2% below its estimated fair value. The current PEG Ratio is 4.65, which is 53% above median its 10-year median of 3.04 and 311.5% above the Vehicles & Parts industry median of 1.13. Standard Motor Products' overall GF Score™ is 85/100 with 5 warning signs to review. Investors should evaluate multiple metrics — including profitability, growth, and financial strength — before making a decision.
How is PEG Ratio calculated?
PEG Ratio is calculated from a company's financial statements. For Standard Motor Products (FRA:SRU), the current PEG Ratio is 4.65 as of Jul. 11, 2026. GuruFocus calculates this using data sourced from SEC filings and annual reports. See the calculation section and 30-year financial data on this page for the full breakdown.
Is Standard Motor Products (FRA:SRU) Overvalued in 2026?
Based on GuruFocus' analysis, Standard Motor Products stock appears to be undervalued.
The current stock price of €32.20 is trading 10.2% below its estimated GF Value™ of €35.86.
Key valuation signals for FRA:SRU:
PEG Ratio: 4.65 (53% above median its 10-year median of 3.04)
GF Value™: €35.86 vs. price of €32.20 (10.2% below fair value)
Industry Position: 311.5% above the Vehicles & Parts median (#554 of 670)
No single metric tells the full story. See the FRA:SRU stock analysis page for a complete view including 30-year financials, guru trades, and insider activity.
Standard Motor Products Inc is a manufacturer and distributor of premium automotive parts used in the maintenance, service, and repair of vehicles in the automotive aftermarket industry. It operates into four business segments namely Engineered Solutions, Vehicle Control, Nissens Automotive, and Temperature Control. It focuses on the original equipment and original equipment services markets, with a product lineup of replacement parts for engine management ignition, emission, and fuel systems, as well as temperature-control products. The company operates majorly in the United States, with additional sales in Canada, Europe, Asia, Mexico, and other Latin American countries.
85GF Score
Get the complete analysis for FRA:SRU
PEG Ratio is just one metric. See GF Value™, 30-year financials, guru trades, warning signs, and more.
Quick Browse
Personalize
Premium Gurus 
Create New Portfolio
FRA:SRU has been successfully added to your 
