* The 5-Year EBITDA Growth Rate is the 5-year average EBITDA per share growth rate. While the denominator is a percentage, we use the whole number as opposed to the decimal form for the calculation. For example, 5% would be shown as 5 as opposed to 0.05. If it's smaller than or equal to 0, then the PEG Ratio is not calculated.
LTS:0F6S'
s PEG Ratio Range Over the Past 10 Years
Min: 1.2 Med: 2.44 Max: 77.78
Current: 2.69
During the past 13 years, Maschinenfabrik Berthold Hermle AG's highest PEG Ratio was 77.78. The lowest was 1.20. And the median was 2.44.
LTS:0F6S's PEG Ratio is ranked worse than 63.3% of 1278
companies
in the Industrial Products industry
Industry Median: 1.8
vs LTS:0F6S: 2.69
Peter Lynch thinks a company with a P/E ratio equal to its growth rate is fairly valued.
Maschinenfabrik Berthold Hermle AG (LTS:0F6S) PEG Ratio Explanation
To compare stocks with different growth rates, Peter Lynch invented a ratio called PEG Ratio. PEG Ratio is defined as the P/E ratio divided by the growth ratio. He thinks a company with a P/E ratio equal to its growth rate is fairly valued. Still he said he would rather buy a company growing 20% a year with a P/E of 20, instead of a company growing 10% a year with a P/E of 10.
Maschinenfabrik Berthold Hermle AG PEG Ratio Related Terms
Maschinenfabrik Berthold Hermle AG PEG Ratio Historical Data
* For Operating Data section: All numbers are indicated by the unit behind each term and all currency related amount are in USD. * For other sections: All numbers are in millions except for per share data, ratio, and percentage. All currency related amount are indicated in the company's associated stock exchange currency.
Maschinenfabrik Berthold Hermle AG PEG Ratio Chart
For the Specialty Industrial Machinery subindustry, Maschinenfabrik Berthold Hermle AG's PEG Ratio, along with its competitors' market caps and PEG Ratio data, can be viewed below:
* Competitive companies are chosen from companies within the same industry, with headquarter located in same country, with closest market capitalization; x-axis shows the market cap, and y-axis shows the term value; the bigger the dot, the larger the market cap. Note that "N/A" values will not show up in the chart.
Maschinenfabrik Berthold Hermle AG PEG Ratio vs Industrial Products Industry
For the Industrial Products industry and Industrials sector, Maschinenfabrik Berthold Hermle AG's PEG Ratio distribution charts can be found below:
* The bar in red indicates where Maschinenfabrik Berthold Hermle AG's PEG Ratio falls into.
* For Operating Data section: All numbers are indicated by the unit behind each term and all currency related amount are in USD. * For other sections: All numbers are in millions except for per share data, ratio, and percentage. All currency related amount are indicated in the company's associated stock exchange currency.
* Note: The 5-Year EBITDA Growth Rate is the 5-year average EBITDA per share growth rate. While the denominator is a percentage, we use the whole number as opposed to the decimal form for the calculation. For example, 5% would be shown as 5 as opposed to 0.05. If it's smaller than or equal to 0, then the PEG Ratio is not calculated.
Maschinenfabrik Berthold Hermle AG (LTS:0F6S) has a PEG Ratio of 2.01 as of Jul. 11, 2026. Price-earnings to growth ratio is the ratio of price-earnings to a company's earnings growth rate. View historical data on Maschinenfabrik Berthold Hermle AG and its competitors. This is 18% below median its historical median of 2.44. Over the past decade, Maschinenfabrik Berthold Hermle AG's PEG Ratio has ranged from 1.20 to 77.78. According to the industry distribution chart, Maschinenfabrik Berthold Hermle AG ranks #809 out of 1278 companies in the Industrial Products industry, placing it in the top 63.3%.
Is Maschinenfabrik Berthold Hermle AG's PEG Ratio too high?
Maschinenfabrik Berthold Hermle AG's current PEG Ratio of 2.01 is 18% below median its 10-year median of 2.44. Over the past 10 years, this metric has ranged from a low of 1.20 to a high of 77.78. The Industrial Products industry median PEG Ratio is 1.80. Maschinenfabrik Berthold Hermle AG's value of 2.01 is 11.7% above this industry median. Based on the distribution chart, Maschinenfabrik Berthold Hermle AG ranks #809 out of 1278 companies in the Industrial Products industry, which is below the industry midpoint. Overall, Maschinenfabrik Berthold Hermle AG has a GF Score™ of 76/100, reflecting its overall financial health beyond just this single metric.
How does Maschinenfabrik Berthold Hermle AG's PEG Ratio compare to GEV and ETN?
According to the Industrial Products industry distribution chart, Maschinenfabrik Berthold Hermle AG ranks #809 out of 1278 companies for PEG Ratio. This places Maschinenfabrik Berthold Hermle AG in the lower half of its industry. The industry median PEG Ratio is 1.80. Maschinenfabrik Berthold Hermle AG's value of 2.01 is 11.7% above this benchmark. Historically, Maschinenfabrik Berthold Hermle AG's own PEG Ratio has ranged from 1.20 to 77.78 over the past decade. While the company's 10-year median is 2.44 vs. the industry median of 1.80, Maschinenfabrik Berthold Hermle AG has consistently been above the industry average. See the competitive comparison table and distribution chart on this page for a detailed peer-by-peer breakdown.
What is a good PEG Ratio for an Industrial Products company?
The median PEG Ratio among Industrial Products companies is 1.80, based on 1,278 companies in the industry. Companies in the top quartile (top 25%) have a PEG Ratio significantly above this median, while those in the bottom quartile fall well below. However, PEG Ratio should not be evaluated in isolation — investors should consider it alongside profitability, growth, and financial strength metrics. Maschinenfabrik Berthold Hermle AG's current PEG Ratio of 2.01 is 11.7% above the industry median. Use the industry distribution chart on this page to see where any company falls relative to its peers.
What does a high PEG Ratio mean?
A high PEG Ratio can signal that a stock is expensive relative to its fundamentals. Price-earnings to growth ratio is the ratio of price-earnings to a company's earnings growth rate. View historical data on Maschinenfabrik Berthold Hermle AG and its competitors. For the Industrial Products industry, the median PEG Ratio is 1.80 — values significantly above this may indicate overvaluation, while values below may suggest a bargain or underlying issues. Maschinenfabrik Berthold Hermle AG's current PEG Ratio is 2.01, which is 18% below median its own 10-year median of 2.44. However, context matters — high-growth companies often justify higher valuations. Always evaluate alongside other metrics like GF Score™ and GF Value™.
Is Maschinenfabrik Berthold Hermle AG stock overvalued right now?
Maschinenfabrik Berthold Hermle AG (LTS:0F6S) has a current PEG Ratio of 2.01. The stock's GF Value™ is €147.03, compared to a current price of €134.00 — trading 8.9% below its estimated fair value. The current PEG Ratio is 2.01, which is 18% below median its 10-year median of 2.44 and 11.7% above the Industrial Products industry median of 1.80. Maschinenfabrik Berthold Hermle AG's overall GF Score™ is 76/100 with 6 warning signs to review. Investors should evaluate multiple metrics — including profitability, growth, and financial strength — before making a decision.
How is PEG Ratio calculated?
PEG Ratio is calculated from a company's financial statements. For Maschinenfabrik Berthold Hermle AG (LTS:0F6S), the current PEG Ratio is 2.01 as of Jul. 11, 2026. GuruFocus calculates this using data sourced from SEC filings and annual reports. See the calculation section and 30-year financial data on this page for the full breakdown.
Is Maschinenfabrik Berthold Hermle AG (LTS:0F6S) Overvalued in 2026?
Based on GuruFocus' analysis, Maschinenfabrik Berthold Hermle AG stock appears to be undervalued.
The current stock price of €134.00 is trading 8.9% below its estimated GF Value™ of €147.03.
Key valuation signals for LTS:0F6S:
PEG Ratio: 2.01 (18% below median its 10-year median of 2.44)
GF Value™: €147.03 vs. price of €134.00 (8.9% below fair value)
Industry Position: 11.7% above the Industrial Products median (#809 of 1278)
No single metric tells the full story. See the LTS:0F6S stock analysis page for a complete view including 30-year financials, guru trades, and insider activity.
Maschinenfabrik Berthold Hermle AG Business Description
Maschinenfabrik Berthold Hermle AG is a Germany-based company that produces universal milling machines and machining centers, offering its customers complete automation solutions under one roof. The company's customers include domestic and international companies in various high-tech sectors, encompassing mechanical and plant engineering with applications for packing technology, mining or the special vehicles segment, the aerospace industry, medical technology, the electronics and chip industry, the optical industry, energy technology, toolmaking and mould construction as well as the automotive industry, including their subcontractors. The group's operating segments include Domestic companies, which derive maximum revenue, and Foreign sales companies.
76GF Score
Get the complete analysis for LTS:0F6S
PEG Ratio is just one metric. See GF Value™, 30-year financials, guru trades, warning signs, and more.
Quick Browse
Personalize
Premium Gurus 
Create New Portfolio
LTS:0F6S has been successfully added to your 
