* The 5-Year EBITDA Growth Rate is the 5-year average EBITDA per share growth rate. While the denominator is a percentage, we use the whole number as opposed to the decimal form for the calculation. For example, 5% would be shown as 5 as opposed to 0.05. If it's smaller than or equal to 0, then the PEG Ratio is not calculated.
The historical rank and industry rank for Takamatsu Construction Group Co's PEG Ratio or its related term are showing as below:
TAKMF'
s PEG Ratio Range Over the Past 10 Years
Min: 0.68 Med: 1.42 Max: 87.4
Current: 1.8
During the past 13 years, Takamatsu Construction Group Co's highest PEG Ratio was 87.40. The lowest was 0.68. And the median was 1.42.
TAKMF's PEG Ratio is ranked worse than 65.11% of 685
companies
in the Construction industry
Industry Median: 1.1
vs TAKMF: 1.80
Peter Lynch thinks a company with a P/E ratio equal to its growth rate is fairly valued.
Takamatsu Construction Group Co (OTCPK:TAKMF) PEG Ratio Explanation
To compare stocks with different growth rates, Peter Lynch invented a ratio called PEG Ratio. PEG Ratio is defined as the P/E ratio divided by the growth ratio. He thinks a company with a P/E ratio equal to its growth rate is fairly valued. Still he said he would rather buy a company growing 20% a year with a P/E of 20, instead of a company growing 10% a year with a P/E of 10.
Takamatsu Construction Group Co PEG Ratio Related Terms
Takamatsu Construction Group Co PEG Ratio Historical Data
* For Operating Data section: All numbers are indicated by the unit behind each term and all currency related amount are in USD. * For other sections: All numbers are in millions except for per share data, ratio, and percentage. All currency related amount are indicated in the company's associated stock exchange currency.
For the Engineering & Construction subindustry, Takamatsu Construction Group Co's PEG Ratio, along with its competitors' market caps and PEG Ratio data, can be viewed below:
* Competitive companies are chosen from companies within the same industry, with headquarter located in same country, with closest market capitalization; x-axis shows the market cap, and y-axis shows the term value; the bigger the dot, the larger the market cap. Note that "N/A" values will not show up in the chart.
Takamatsu Construction Group Co PEG Ratio vs Construction Industry
For the Construction industry and Industrials sector, Takamatsu Construction Group Co's PEG Ratio distribution charts can be found below:
* The bar in red indicates where Takamatsu Construction Group Co's PEG Ratio falls into.
* For Operating Data section: All numbers are indicated by the unit behind each term and all currency related amount are in USD. * For other sections: All numbers are in millions except for per share data, ratio, and percentage. All currency related amount are indicated in the company's associated stock exchange currency.
* Note: The 5-Year EBITDA Growth Rate is the 5-year average EBITDA per share growth rate. While the denominator is a percentage, we use the whole number as opposed to the decimal form for the calculation. For example, 5% would be shown as 5 as opposed to 0.05. If it's smaller than or equal to 0, then the PEG Ratio is not calculated.
Takamatsu Construction Group Co (TAKMF) has a PEG Ratio of 1.54 as of Jul. 02, 2026. Price-earnings to growth ratio is the ratio of price-earnings to a company's earnings growth rate. View historical data on Takamatsu Construction Group Co and its competitors. This is near median its historical median of 1.42. Over the past decade, Takamatsu Construction Group Co's PEG Ratio has ranged from 0.68 to 87.40. According to the industry distribution chart, Takamatsu Construction Group Co ranks #446 out of 685 companies in the Construction industry, placing it in the top 65.1%.
Is Takamatsu Construction Group Co's PEG Ratio too high?
Takamatsu Construction Group Co's current PEG Ratio of 1.54 is near median its 10-year median of 1.42. Over the past 10 years, this metric has ranged from a low of 0.68 to a high of 87.40. The Construction industry median PEG Ratio is 1.10. Takamatsu Construction Group Co's value of 1.54 is 40% above this industry median. Based on the distribution chart, Takamatsu Construction Group Co ranks #446 out of 685 companies in the Construction industry, which is below the industry midpoint. Overall, Takamatsu Construction Group Co has a GF Score™ of 90/100, reflecting its overall financial health beyond just this single metric.
How does Takamatsu Construction Group Co's PEG Ratio compare to PWR and FIX?
According to the Construction industry distribution chart, Takamatsu Construction Group Co ranks #446 out of 685 companies for PEG Ratio. This places Takamatsu Construction Group Co in the lower half of its industry. The industry median PEG Ratio is 1.10. Takamatsu Construction Group Co's value of 1.54 is 40% above this benchmark. Historically, Takamatsu Construction Group Co's own PEG Ratio has ranged from 0.68 to 87.40 over the past decade. While the company's 10-year median is 1.42 vs. the industry median of 1.10, Takamatsu Construction Group Co has consistently been above the industry average. See the competitive comparison table and distribution chart on this page for a detailed peer-by-peer breakdown.
What is a good PEG Ratio for a Construction company?
The median PEG Ratio among Construction companies is 1.10, based on 685 companies in the industry. Companies in the top quartile (top 25%) have a PEG Ratio significantly above this median, while those in the bottom quartile fall well below. However, PEG Ratio should not be evaluated in isolation — investors should consider it alongside profitability, growth, and financial strength metrics. Takamatsu Construction Group Co's current PEG Ratio of 1.54 is 40% above the industry median. Use the industry distribution chart on this page to see where any company falls relative to its peers.
What does a high PEG Ratio mean?
A high PEG Ratio can signal that a stock is expensive relative to its fundamentals. Price-earnings to growth ratio is the ratio of price-earnings to a company's earnings growth rate. View historical data on Takamatsu Construction Group Co and its competitors. For the Construction industry, the median PEG Ratio is 1.10 — values significantly above this may indicate overvaluation, while values below may suggest a bargain or underlying issues. Takamatsu Construction Group Co's current PEG Ratio is 1.54, which is near median its own 10-year median of 1.42. However, context matters — high-growth companies often justify higher valuations. Always evaluate alongside other metrics like GF Score™ and GF Value™.
Is Takamatsu Construction Group Co stock overvalued right now?
Takamatsu Construction Group Co (TAKMF) has a current PEG Ratio of 1.54. The stock's GF Value™ is $18.84, compared to a current price of $19.55 — trading 3.8% above its estimated fair value. The current PEG Ratio is 1.54, which is near median its 10-year median of 1.42 and 40% above the Construction industry median of 1.10. Takamatsu Construction Group Co's overall GF Score™ is 90/100 with 2 warning signs to review. Investors should evaluate multiple metrics — including profitability, growth, and financial strength — before making a decision.
How is PEG Ratio calculated?
PEG Ratio is calculated from a company's financial statements. For Takamatsu Construction Group Co (TAKMF), the current PEG Ratio is 1.54 as of Jul. 02, 2026. GuruFocus calculates this using data sourced from SEC filings and annual reports. See the calculation section and 30-year financial data on this page for the full breakdown.
Is Takamatsu Construction Group Co (TAKMF) Overvalued in 2026?
Based on GuruFocus' analysis, Takamatsu Construction Group Co stock appears to be overvalued.
The current stock price of $19.55 is trading 3.8% above its estimated GF Value™ of $18.84.
Key valuation signals for TAKMF:
PEG Ratio: 1.54 (near median its 10-year median of 1.42)
GF Value™: $18.84 vs. price of $19.55 (3.8% above fair value)
Industry Position: 40% above the Construction median (#446 of 685)
No single metric tells the full story. See the TAKMF stock analysis page for a complete view including 30-year financials, guru trades, and insider activity.
Takamatsu Construction Group Co Business Description
Takamatsu Construction Group Co Ltd is a Japan-based company, engages in the construction business. It operates through the following business division Construction business, Civil Engineering business, and Real Estate business. The Construction division offers general construction, remodeling, and renovation of residential and commercial buildings, and warehouses. The Civil Engineering division deals with the construction, repair, and maintenance of bridges, highways, tunnels, roads, and sewage systems. The Real Estate division offers real estate development, sales, leasing, and management.
90GF Score
Get the complete analysis for TAKMF
PEG Ratio is just one metric. See GF Value™, 30-year financials, guru trades, warning signs, and more.
Quick Browse
Personalize
Premium Gurus 
Create New Portfolio
TAKMF has been successfully added to your 
