Axtec (ASX:AXI) 5-Year Yield-on-Cost %: 0.00 (As of Jul. 04, 2026)


What is Axtec 5-Year Yield-on-Cost %?

Axtec ASX:AXI 5-Year Yield-on-Cost % is 0.00 as of Jul. 04, 2026. The stock has 7 warning signs investors should review. Among 1,925 Industrial Products companies, Axtec ranks worse than 51948% on this metric.

Axtec's yield on cost for the quarter that ended in Dec. 2025 was 0.00.


The historical rank and industry rank for Axtec's 5-Year Yield-on-Cost % or its related term are showing as below:


During the past 13 years, Axtec's highest Yield on Cost was 88.89. The lowest was 15.00. And the median was 36.60.


ASX:AXI's 5-Year Yield-on-Cost % is not ranked *
in the Industrial Products industry.
Industry Median: 1.76
* Ranked among companies with meaningful 5-Year Yield-on-Cost % only.

Axtec  (ASX:AXI) 5-Year Yield-on-Cost % Explanation

Of course the risk here is that the company may not raise its dividends as it did before. The key is to select the companies that can consistently raise its dividends. Usually companies with long history of raising dividends tend to do so.

Axtec 5-Year Yield-on-Cost % Related Terms

ASX:AXI vs GEV, ETN, PH: 5-Year Yield-on-Cost % Comparison

For the Specialty Industrial Machinery subindustry, Axtec's 5-Year Yield-on-Cost %, along with its competitors' market caps and 5-Year Yield-on-Cost % data, can be viewed below:

* Competitive companies are chosen from companies within the same industry, with headquarter located in same country, with closest market capitalization; x-axis shows the market cap, and y-axis shows the term value; the bigger the dot, the larger the market cap. Note that "N/A" values will not show up in the chart.

Axtec 5-Year Yield-on-Cost % vs Industrial Products Industry

For the Industrial Products industry and Industrials sector, Axtec's 5-Year Yield-on-Cost % distribution charts can be found below:

* The bar in red indicates where Axtec's 5-Year Yield-on-Cost % falls into.


Axtec 5-Year Yield-on-Cost % Calculation

Dividend Yield % and dividend growth of a stock is an important factor for income investors. But if company A raises its dividend constantly faster than company B, company A's future dividend yield might be much higher than Company B's even if their yields are the same now and their stock prices do not change.

Yield on Cost assumes that you buy and the stock today, and hold it for 5 years. If the company raises it dividends at the same rate as it did over the past 5 years, the dividends investors receive annually in 5 years relative to the stock price today.

Therefore, Yield-on-Cost of Axtec is calculated as

Yield-on-Cost=Dividend Yield %*(1+Dividend Growth Rate)^5
Frequently Asked Questions Learn more about 5-Year Yield-on-Cost % →
What does a 5-Year Yield-on-Cost % of 0.00 mean?
Axtec (ASX:AXI) has a 5-Year Yield-on-Cost % of 0.00 as of Jul. 04, 2026. 5-Year Yield on Cost measures the expected yield based on a company's current yield and 5-year dividend growth. View historical data on Axtec and its competitors. Over the past decade, Axtec's 5-Year Yield-on-Cost % has ranged from 15.00 to 88.89. According to the industry distribution chart, Axtec ranks #999999 out of 1925 companies in the Industrial Products industry.
Is Axtec's 5-Year Yield-on-Cost % too high?
Axtec's current 5-Year Yield-on-Cost % is 0.00. Over the past 10 years, this metric has ranged from a low of 15.00 to a high of 88.89. Based on the distribution chart, Axtec ranks #999999 out of 1925 companies in the Industrial Products industry, which is in the bottom quartile relative to peers.
How does Axtec's 5-Year Yield-on-Cost % compare to GEV and ETN?
According to the Industrial Products industry distribution chart, Axtec ranks #999999 out of 1925 companies for 5-Year Yield-on-Cost %. This places Axtec in the lower half of its industry. The industry median 5-Year Yield-on-Cost % is 1.76. Historically, Axtec's own 5-Year Yield-on-Cost % has ranged from 15.00 to 88.89 over the past decade. See the competitive comparison table and distribution chart on this page for a detailed peer-by-peer breakdown.
What is a good 5-Year Yield-on-Cost % for an Industrial Products company?
The median 5-Year Yield-on-Cost % among Industrial Products companies is 1.76, based on 1,925 companies in the industry. Companies in the top quartile (top 25%) have a 5-Year Yield-on-Cost % significantly above this median, while those in the bottom quartile fall well below. However, 5-Year Yield-on-Cost % should not be evaluated in isolation — investors should consider it alongside profitability, growth, and financial strength metrics. Use the industry distribution chart on this page to see where any company falls relative to its peers.
What does a high 5-Year Yield-on-Cost % mean?
A high 5-Year Yield-on-Cost % can signal that a stock is expensive relative to its fundamentals. 5-Year Yield on Cost measures the expected yield based on a company's current yield and 5-year dividend growth. View historical data on Axtec and its competitors. For the Industrial Products industry, the median 5-Year Yield-on-Cost % is 1.76 — values significantly above this may indicate overvaluation, while values below may suggest a bargain or underlying issues. Axtec's current 5-Year Yield-on-Cost % is 0.00. However, context matters — high-growth companies often justify higher valuations. Always evaluate alongside other metrics like GF Score™ and GF Value™.
Is Axtec stock overvalued right now?
Based on GuruFocus' analysis, Axtec (ASX:AXI) is currently considered Possible Value Trap. The stock's GF Value™ is A$0.02, compared to a current price of A$0.01 — trading 35% below its estimated fair value. The current 5-Year Yield-on-Cost % is 0.00. Investors should evaluate multiple metrics — including profitability, growth, and financial strength — before making a decision.
How is 5-Year Yield-on-Cost % calculated?
5-Year Yield-on-Cost % is calculated from a company's financial statements. For Axtec (ASX:AXI), the current 5-Year Yield-on-Cost % is 0.00 as of Jul. 04, 2026. GuruFocus calculates this using data sourced from SEC filings and annual reports. See the calculation section and 30-year financial data on this page for the full breakdown.

Axtec Business Description

Address 264-278 George Street, Suite 2007, Level 20 Australia Square, Sydney, NSW, AUS, 2000
Axtec Ltd operates in the Industrial Weighing & Measurement Equipment industry. The company is engaged in designing and manufacturing, installing, and service axle weighing and weighbridge systems that measure vehicle loads.