Schweiter Technologies AGSCWTF 67 5-Year Yield-on-Cost % is 1.56 as of Jul. 07, 2026, which is 36% above its 10-year median of 1.15. GuruFocus rates SCWTF with a GF Score™ of 67/100 and a GF Value™ of $448.00. The stock has 3 warning signs investors should review. Among 1,014 Construction companies, Schweiter Technologies AG ranks worse than 74.85% on this metric.
The historical rank and industry rank for Schweiter Technologies AG's 5-Year Yield-on-Cost % or its related term are showing as below:
SCWTF'
s 5-Year Yield-on-Cost % Range Over the Past 10 Years
Min: 0.73 Med: 1.15 Max: 2.45
Current: 1.56
During the past 13 years, Schweiter Technologies AG's highest Yield on Cost was 2.45. The lowest was 0.73. And the median was 1.15.
SCWTF's 5-Year Yield-on-Cost % is ranked worse than 74.85% of 1014
companies
in the Construction industry
Industry Median: 3.395
vs SCWTF: 1.56
Schweiter Technologies AG (OTCPK:SCWTF) 5-Year Yield-on-Cost % Explanation
Of course the risk here is that the company may not raise its dividends as it did before. The key is to select the companies that can consistently raise its dividends. Usually companies with long history of raising dividends tend to do so.
Schweiter Technologies AG 5-Year Yield-on-Cost % Related Terms
SCWTF vs TT, JCI, CARR: 5-Year Yield-on-Cost % Comparison
For the Building Products & Equipment subindustry, Schweiter Technologies AG's 5-Year Yield-on-Cost %, along with its competitors' market caps and 5-Year Yield-on-Cost % data, can be viewed below:
* Competitive companies are chosen from companies within the same industry, with headquarter located in same country, with closest market capitalization; x-axis shows the market cap, and y-axis shows the term value; the bigger the dot, the larger the market cap. Note that "N/A" values will not show up in the chart.
Schweiter Technologies AG 5-Year Yield-on-Cost % vs Construction Industry
For the Construction industry and Industrials sector, Schweiter Technologies AG's 5-Year Yield-on-Cost % distribution charts can be found below:
* The bar in red indicates where Schweiter Technologies AG's 5-Year Yield-on-Cost % falls into.
Schweiter Technologies AG 5-Year Yield-on-Cost % Calculation
Dividend Yield % and dividend growth of a stock is an important factor for income investors. But if company A raises its dividend constantly faster than company B, company A's future dividend yield might be much higher than Company B's even if their yields are the same now and their stock prices do not change.
Yield on Cost assumes that you buy and the stock today, and hold it for 5 years. If the company raises it dividends at the same rate as it did over the past 5 years, the dividends investors receive annually in 5 years relative to the stock price today.
Schweiter Technologies AG (SCWTF) has a 5-Year Yield-on-Cost % of 1.56 as of Jul. 07, 2026. 5-Year Yield on Cost measures the expected yield based on a company's current yield and 5-year dividend growth. View historical data on Schweiter Technologies AG and its competitors. This is 36% above median its historical median of 1.15. Over the past decade, Schweiter Technologies AG's 5-Year Yield-on-Cost % has ranged from 0.73 to 2.45. According to the industry distribution chart, Schweiter Technologies AG ranks #759 out of 1014 companies in the Construction industry, placing it in the top 74.9%.
Is Schweiter Technologies AG's 5-Year Yield-on-Cost % too high?
Schweiter Technologies AG's current 5-Year Yield-on-Cost % of 1.56 is 36% above median its 10-year median of 1.15. Over the past 10 years, this metric has ranged from a low of 0.73 to a high of 2.45. The Construction industry median 5-Year Yield-on-Cost % is 3.40. Schweiter Technologies AG's value of 1.56 is 54.1% below this industry median. Based on the distribution chart, Schweiter Technologies AG ranks #759 out of 1014 companies in the Construction industry, which is below the industry midpoint. Overall, Schweiter Technologies AG has a GF Score™ of 67/100, reflecting its overall financial health beyond just this single metric.
How does Schweiter Technologies AG's 5-Year Yield-on-Cost % compare to TT and JCI?
According to the Construction industry distribution chart, Schweiter Technologies AG ranks #759 out of 1014 companies for 5-Year Yield-on-Cost %. This places Schweiter Technologies AG in the lower half of its industry. The industry median 5-Year Yield-on-Cost % is 3.40. Schweiter Technologies AG's value of 1.56 is 54.1% below this benchmark. Historically, Schweiter Technologies AG's own 5-Year Yield-on-Cost % has ranged from 0.73 to 2.45 over the past decade. While the company's 10-year median is 1.15 vs. the industry median of 3.40, Schweiter Technologies AG has consistently been below the industry average. See the competitive comparison table and distribution chart on this page for a detailed peer-by-peer breakdown.
What is a good 5-Year Yield-on-Cost % for a Construction company?
The median 5-Year Yield-on-Cost % among Construction companies is 3.40, based on 1,014 companies in the industry. Companies in the top quartile (top 25%) have a 5-Year Yield-on-Cost % significantly above this median, while those in the bottom quartile fall well below. However, 5-Year Yield-on-Cost % should not be evaluated in isolation — investors should consider it alongside profitability, growth, and financial strength metrics. Schweiter Technologies AG's current 5-Year Yield-on-Cost % of 1.56 is 54.1% below the industry median. Use the industry distribution chart on this page to see where any company falls relative to its peers.
What does a high 5-Year Yield-on-Cost % mean?
A high 5-Year Yield-on-Cost % can signal that a stock is expensive relative to its fundamentals. 5-Year Yield on Cost measures the expected yield based on a company's current yield and 5-year dividend growth. View historical data on Schweiter Technologies AG and its competitors. For the Construction industry, the median 5-Year Yield-on-Cost % is 3.40 — values significantly above this may indicate overvaluation, while values below may suggest a bargain or underlying issues. Schweiter Technologies AG's current 5-Year Yield-on-Cost % is 1.56, which is 36% above median its own 10-year median of 1.15. However, context matters — high-growth companies often justify higher valuations. Always evaluate alongside other metrics like GF Score™ and GF Value™.
Is Schweiter Technologies AG stock overvalued right now?
Schweiter Technologies AG (SCWTF) has a current 5-Year Yield-on-Cost % of 1.56. The stock's GF Value™ is $448.00, compared to a current price of $362.75 — trading 19% below its estimated fair value. The current 5-Year Yield-on-Cost % is 1.56, which is 36% above median its 10-year median of 1.15 and 54.1% below the Construction industry median of 3.40. Schweiter Technologies AG's overall GF Score™ is 67/100 with 3 warning signs to review. Investors should evaluate multiple metrics — including profitability, growth, and financial strength — before making a decision.
How is 5-Year Yield-on-Cost % calculated?
5-Year Yield-on-Cost % is calculated from a company's financial statements. For Schweiter Technologies AG (SCWTF), the current 5-Year Yield-on-Cost % is 1.56 as of Jul. 07, 2026. GuruFocus calculates this using data sourced from SEC filings and annual reports. See the calculation section and 30-year financial data on this page for the full breakdown.
Is Schweiter Technologies AG (SCWTF) Overvalued in 2026?
Based on GuruFocus' analysis, Schweiter Technologies AG stock appears to be undervalued.
The current stock price of $362.75 is trading 19% below its estimated GF Value™ of $448.00.
Key valuation signals for SCWTF:
5-Year Yield-on-Cost %: 1.56 (36% above median its 10-year median of 1.15)
GF Value™: $448.00 vs. price of $362.75 (19% below fair value)
Industry Position: 54.1% below the Construction median (#759 of 1014)
No single metric tells the full story. See the SCWTF stock analysis page for a complete view including 30-year financials, guru trades, and insider activity.
Schweiter Technologies AG focuses on composite material solutions through its division, 3A Composites. Its activities include the development, production and distribution of high-quality composites, synthetic sheets, foamboards and core materials based on balsa wood and PET foam, used in lightweight applications such as visual communication (display), architecture, wind energy, industry, railway and bus construction, and shipbuilding. The Company operates through the 3A Composites segment, which develops and commercializes composites and lightweight boards and includes brands such as ALUCOBOND, AIREX, BALTEK and DIBOND. It generates maximum revenue from Europe, followed by the Americas, Asia-Pacific and Africa.
67GF Score
Get the complete analysis for SCWTF
5-Year Yield-on-Cost % is just one metric. See GF Value™, 30-year financials, guru trades, warning signs, and more.
Quick Browse
Personalize
Premium Gurus 
Create New Portfolio
SCWTF has been successfully added to your 