The historical rank and industry rank for Tokyo Steel Manufacturing Co's 5-Year Yield-on-Cost % or its related term are showing as below:
TOKSF'
s 5-Year Yield-on-Cost % Range Over the Past 10 Years
Min: 2.67 Med: 6.06 Max: 11.55
Current: 10.83
During the past 13 years, Tokyo Steel Manufacturing Co's highest Yield on Cost was 11.55. The lowest was 2.67. And the median was 6.06.
TOKSF's 5-Year Yield-on-Cost % is ranked better than 81.45% of 318
companies
in the Steel industry
Industry Median: 3.315
vs TOKSF: 10.83
Tokyo Steel Manufacturing Co (OTCPK:TOKSF) 5-Year Yield-on-Cost % Explanation
Of course the risk here is that the company may not raise its dividends as it did before. The key is to select the companies that can consistently raise its dividends. Usually companies with long history of raising dividends tend to do so.
Tokyo Steel Manufacturing Co 5-Year Yield-on-Cost % Related Terms
TOKSF vs NUE, STLD, RS: 5-Year Yield-on-Cost % Comparison
For the Steel subindustry, Tokyo Steel Manufacturing Co's 5-Year Yield-on-Cost %, along with its competitors' market caps and 5-Year Yield-on-Cost % data, can be viewed below:
* Competitive companies are chosen from companies within the same industry, with headquarter located in same country, with closest market capitalization; x-axis shows the market cap, and y-axis shows the term value; the bigger the dot, the larger the market cap. Note that "N/A" values will not show up in the chart.
Tokyo Steel Manufacturing Co 5-Year Yield-on-Cost % vs Steel Industry
For the Steel industry and Basic Materials sector, Tokyo Steel Manufacturing Co's 5-Year Yield-on-Cost % distribution charts can be found below:
* The bar in red indicates where Tokyo Steel Manufacturing Co's 5-Year Yield-on-Cost % falls into.
Tokyo Steel Manufacturing Co 5-Year Yield-on-Cost % Calculation
Dividend Yield % and dividend growth of a stock is an important factor for income investors. But if company A raises its dividend constantly faster than company B, company A's future dividend yield might be much higher than Company B's even if their yields are the same now and their stock prices do not change.
Yield on Cost assumes that you buy and the stock today, and hold it for 5 years. If the company raises it dividends at the same rate as it did over the past 5 years, the dividends investors receive annually in 5 years relative to the stock price today.
Tokyo Steel Manufacturing Co (TOKSF) has a 5-Year Yield-on-Cost % of 10.83 as of Jul. 08, 2026. 5-Year Yield on Cost measures the expected yield based on a company's current yield and 5-year dividend growth. View historical data on Tokyo Steel Manufacturing Co and its competitors. This is 79% above median its historical median of 6.06. Over the past decade, Tokyo Steel Manufacturing Co's 5-Year Yield-on-Cost % has ranged from 2.67 to 11.55. According to the industry distribution chart, Tokyo Steel Manufacturing Co ranks #59 out of 318 companies in the Steel industry, placing it in the top 18.6%.
Is Tokyo Steel Manufacturing Co's 5-Year Yield-on-Cost % too high?
Tokyo Steel Manufacturing Co's current 5-Year Yield-on-Cost % of 10.83 is 79% above median its 10-year median of 6.06. Over the past 10 years, this metric has ranged from a low of 2.67 to a high of 11.55. The Steel industry median 5-Year Yield-on-Cost % is 3.32. Tokyo Steel Manufacturing Co's value of 10.83 is 226.7% above this industry median. Based on the distribution chart, Tokyo Steel Manufacturing Co ranks #59 out of 318 companies in the Steel industry, which is in the top quartile — a strong position relative to peers. Overall, Tokyo Steel Manufacturing Co has a GF Score™ of 76/100, reflecting its overall financial health beyond just this single metric.
How does Tokyo Steel Manufacturing Co's 5-Year Yield-on-Cost % compare to NUE and STLD?
According to the Steel industry distribution chart, Tokyo Steel Manufacturing Co ranks #59 out of 318 companies for 5-Year Yield-on-Cost %. This places Tokyo Steel Manufacturing Co in the top 19% of its industry — outperforming the majority of peers. The industry median 5-Year Yield-on-Cost % is 3.32. Tokyo Steel Manufacturing Co's value of 10.83 is 226.7% above this benchmark. Historically, Tokyo Steel Manufacturing Co's own 5-Year Yield-on-Cost % has ranged from 2.67 to 11.55 over the past decade. While the company's 10-year median is 6.06 vs. the industry median of 3.32, Tokyo Steel Manufacturing Co has consistently been above the industry average. See the competitive comparison table and distribution chart on this page for a detailed peer-by-peer breakdown.
What is a good 5-Year Yield-on-Cost % for a Steel company?
The median 5-Year Yield-on-Cost % among Steel companies is 3.32, based on 318 companies in the industry. Companies in the top quartile (top 25%) have a 5-Year Yield-on-Cost % significantly above this median, while those in the bottom quartile fall well below. However, 5-Year Yield-on-Cost % should not be evaluated in isolation — investors should consider it alongside profitability, growth, and financial strength metrics. Tokyo Steel Manufacturing Co's current 5-Year Yield-on-Cost % of 10.83 is 226.7% above the industry median. Use the industry distribution chart on this page to see where any company falls relative to its peers.
What does a high 5-Year Yield-on-Cost % mean?
A high 5-Year Yield-on-Cost % can signal that a stock is expensive relative to its fundamentals. 5-Year Yield on Cost measures the expected yield based on a company's current yield and 5-year dividend growth. View historical data on Tokyo Steel Manufacturing Co and its competitors. For the Steel industry, the median 5-Year Yield-on-Cost % is 3.32 — values significantly above this may indicate overvaluation, while values below may suggest a bargain or underlying issues. Tokyo Steel Manufacturing Co's current 5-Year Yield-on-Cost % is 10.83, which is 79% above median its own 10-year median of 6.06. However, context matters — high-growth companies often justify higher valuations. Always evaluate alongside other metrics like GF Score™ and GF Value™.
Is Tokyo Steel Manufacturing Co stock overvalued right now?
Tokyo Steel Manufacturing Co (TOKSF) has a current 5-Year Yield-on-Cost % of 10.83. The stock's GF Value™ is $7.82, compared to a current price of $9.11 — trading 16.4% above its estimated fair value. The current 5-Year Yield-on-Cost % is 10.83, which is 79% above median its 10-year median of 6.06 and 226.7% above the Steel industry median of 3.32. Tokyo Steel Manufacturing Co's overall GF Score™ is 76/100 with 10 warning signs to review. Investors should evaluate multiple metrics — including profitability, growth, and financial strength — before making a decision.
How is 5-Year Yield-on-Cost % calculated?
5-Year Yield-on-Cost % is calculated from a company's financial statements. For Tokyo Steel Manufacturing Co (TOKSF), the current 5-Year Yield-on-Cost % is 10.83 as of Jul. 08, 2026. GuruFocus calculates this using data sourced from SEC filings and annual reports. See the calculation section and 30-year financial data on this page for the full breakdown.
Is Tokyo Steel Manufacturing Co (TOKSF) Overvalued in 2026?
Based on GuruFocus' analysis, Tokyo Steel Manufacturing Co stock appears to be overvalued.
The current stock price of $9.11 is trading 16.4% above its estimated GF Value™ of $7.82.
Key valuation signals for TOKSF:
5-Year Yield-on-Cost %: 10.83 (79% above median its 10-year median of 6.06)
GF Value™: $7.82 vs. price of $9.11 (16.4% above fair value)
Industry Position: 226.7% above the Steel median (#59 of 318)
No single metric tells the full story. See the TOKSF stock analysis page for a complete view including 30-year financials, guru trades, and insider activity.
Tokyo Steel Manufacturing Co Ltd is a Japan-based company engaged in production of long steel products and flat steel products. The company's long product portfolio comprises H beams, sheet piles, I-beams, checkered H-beams, channels, and reinforcing bars. The company's flat product portfolio consists of heavy plates, hot-rolled coils, pickled and oiled coils, hot-dip galvanized coils, checkered coils, and steel sheets. These products are used in a broad range of applications, including construction, civil engineering, industrial equipment, plant equipment, bridge, and shipbuilding. The company has four plants located in Tahara, Okayama, Kyushu, and Utsunomiya. Tokyo Steel Manufacturing generates the majority of its revenue from the Japanese domestic market.
76GF Score
Get the complete analysis for TOKSF
5-Year Yield-on-Cost % is just one metric. See GF Value™, 30-year financials, guru trades, warning signs, and more.
Quick Browse
Personalize
Premium Gurus 
Create New Portfolio
TOKSF has been successfully added to your 