Unimit Engineering PCLBKK:UEC-R 49 Debt-to-EBITDA is 1.64 as of Mar. 2026, which is 8100% above its 10-year median of 0.02. GuruFocus rates BKK:UEC-R with a GF Score™ of 49/100 and a GF Value™ of ฿0.58. The stock has 8 warning signs investors should review. Among 492 Steel companies, Unimit Engineering PCL ranks worse than 203251.83% on this metric.
Debt-to-EBITDA measures a company's ability to pay off its debt.
A high Debt-to-EBITDA ratio generally means that a company may spend more time to paying off its debt. According to Joel Tillinghast's BIG MONEY THINKS SMALL: Biases, Blind Spots, and Smarter Investing, a ratio of Debt-to-EBITDA exceeding four is usually considered scary unless tangible assets cover the debt.
The historical rank and industry rank for Unimit Engineering PCL's Debt-to-EBITDA or its related term are showing as below:
BKK:UEC-R'
s Debt-to-EBITDA Range Over the Past 10 Years
Min: -0.23 Med: 0.02 Max: 1.01
Current: -0.15
During the past 13 years, the highest Debt-to-EBITDA Ratio of Unimit Engineering PCL was 1.01. The lowest was -0.23. And the median was 0.02.
BKK:UEC-R's Debt-to-EBITDA is ranked worse than 100% of 492
companies
in the Steel industry
Industry Median: 2.87
vs BKK:UEC-R: -0.15
A high Debt-to-EBITDA ratio generally means that a company may spend more time to paying off its debt.
According to Joel Tillinghast's BIG MONEY THINKS SMALL: Biases, Blind Spots, and Smarter Investing, a ratio of Debt-to-EBITDA exceeding four is usually considered scary unless tangible assets cover the debt.
Unimit Engineering PCL Debt-to-EBITDA Related Terms
Unimit Engineering PCL Debt-to-EBITDA Historical Data
* Premium members only.
The historical data trend for Unimit Engineering PCL's Debt-to-EBITDA can be seen below:
* For Operating Data section: All numbers are indicated by the unit behind each term and all currency related amount are in USD. * For other sections: All numbers are in millions except for per share data, ratio, and percentage. All currency related amount are indicated in the company's associated stock exchange currency.
BKK:UEC-R vs NUE, STLD, RS: Debt-to-EBITDA Comparison
For the Steel subindustry, Unimit Engineering PCL's Debt-to-EBITDA, along with its competitors' market caps and Debt-to-EBITDA data, can be viewed below:
* Competitive companies are chosen from companies within the same industry, with headquarter located in same country, with closest market capitalization; x-axis shows the market cap, and y-axis shows the term value; the bigger the dot, the larger the market cap. Note that "N/A" values will not show up in the chart.
Unimit Engineering PCL Debt-to-EBITDA vs Steel Industry
For the Steel industry and Basic Materials sector, Unimit Engineering PCL's Debt-to-EBITDA distribution charts can be found below:
* The bar in red indicates where Unimit Engineering PCL's Debt-to-EBITDA falls into.
* For Operating Data section: All numbers are indicated by the unit behind each term and all currency related amount are in USD. * For other sections: All numbers are in millions except for per share data, ratio, and percentage. All currency related amount are indicated in the company's associated stock exchange currency.
In the calculation of annual Debt-to-EBITDA, the EBITDA of the last fiscal year is used. In calculating the annualized quarterly data,
the EBITDA data used here is four times the quarterly (Mar. 2026) EBITDA data.
Unimit Engineering PCL (BKK:UEC-R) has a Debt-to-EBITDA of 1.64 as of Mar. 2026. Debt-to-EBITDA ratio represents the ratio of total debt to total earnings before interest, taxes, depreciation and amortization. View historical data on Unimit Engineering PCL. This is 8100% above median its historical median of 0.02. According to the industry distribution chart, Unimit Engineering PCL ranks #999999 out of 492 companies in the Steel industry.
Is Unimit Engineering PCL's Debt-to-EBITDA too high?
Unimit Engineering PCL's current Debt-to-EBITDA of 1.64 is 8100% above median its 10-year median of 0.02. The Steel industry median Debt-to-EBITDA is 2.87. Unimit Engineering PCL's value of 1.64 is 42.9% below this industry median. Based on the distribution chart, Unimit Engineering PCL ranks #999999 out of 492 companies in the Steel industry, which is in the bottom quartile relative to peers. Overall, Unimit Engineering PCL has a GF Score™ of 49/100, reflecting its overall financial health beyond just this single metric.
How does Unimit Engineering PCL's Debt-to-EBITDA compare to NUE and STLD?
According to the Steel industry distribution chart, Unimit Engineering PCL ranks #999999 out of 492 companies for Debt-to-EBITDA. This places Unimit Engineering PCL in the lower half of its industry. The industry median Debt-to-EBITDA is 2.87. Unimit Engineering PCL's value of 1.64 is 42.9% below this benchmark. While the company's 10-year median is 0.02 vs. the industry median of 2.87, Unimit Engineering PCL has consistently been below the industry average. See the competitive comparison table and distribution chart on this page for a detailed peer-by-peer breakdown.
What is a good Debt-to-EBITDA for a Steel company?
The median Debt-to-EBITDA among Steel companies is 2.87, based on 492 companies in the industry. Companies in the top quartile (top 25%) have a Debt-to-EBITDA significantly above this median, while those in the bottom quartile fall well below. However, Debt-to-EBITDA should not be evaluated in isolation — investors should consider it alongside profitability, growth, and financial strength metrics. Unimit Engineering PCL's current Debt-to-EBITDA of 1.64 is 42.9% below the industry median. Use the industry distribution chart on this page to see where any company falls relative to its peers.
What does a high Debt-to-EBITDA mean?
A high Debt-to-EBITDA can signal that a stock is expensive relative to its fundamentals. Debt-to-EBITDA ratio represents the ratio of total debt to total earnings before interest, taxes, depreciation and amortization. View historical data on Unimit Engineering PCL. For the Steel industry, the median Debt-to-EBITDA is 2.87 — values significantly above this may indicate overvaluation, while values below may suggest a bargain or underlying issues. Unimit Engineering PCL's current Debt-to-EBITDA is 1.64, which is 8100% above median its own 10-year median of 0.02. However, context matters — high-growth companies often justify higher valuations. Always evaluate alongside other metrics like GF Score™ and GF Value™.
Is Unimit Engineering PCL stock overvalued right now?
Unimit Engineering PCL (BKK:UEC-R) has a current Debt-to-EBITDA of 1.64. The stock's GF Value™ is ฿0.58, compared to a current price of ฿0.62 — trading 6.9% above its estimated fair value. The current Debt-to-EBITDA is 1.64, which is 8100% above median its 10-year median of 0.02 and 42.9% below the Steel industry median of 2.87. Unimit Engineering PCL's overall GF Score™ is 49/100 with 8 warning signs to review. Investors should evaluate multiple metrics — including profitability, growth, and financial strength — before making a decision.
How is Debt-to-EBITDA calculated?
Debt-to-EBITDA is calculated from a company's financial statements. For Unimit Engineering PCL (BKK:UEC-R), the current Debt-to-EBITDA is 1.64 as of Mar. 2026. GuruFocus calculates this using data sourced from SEC filings and annual reports. See the calculation section and 30-year financial data on this page for the full breakdown.
Is Unimit Engineering PCL (BKK:UEC-R) Overvalued in 2026?
Based on GuruFocus' analysis, Unimit Engineering PCL stock appears to be overvalued.
The current stock price of ฿0.62 is trading 6.9% above its estimated GF Value™ of ฿0.58.
Key valuation signals for BKK:UEC-R:
Debt-to-EBITDA: 1.64 (8100% above median its 10-year median of 0.02)
GF Value™: ฿0.58 vs. price of ฿0.62 (6.9% above fair value)
Industry Position: 42.9% below the Steel median (#999999 of 492)
No single metric tells the full story. See the BKK:UEC-R stock analysis page for a complete view including 30-year financials, guru trades, and insider activity.
Unimit Engineering PCL is engaged in designing, shop fabrication, field installation, and erection of steel products and construction works such as pressurized equipment and vessels, non-pressure storage, mechanical parts, and piping systems. Its products include Pressure Vessels; Machinery Parts; Storage Tanks; Structure/Piping; and Mechanical Installation. The Group is principally engaged in the steel products. Geographically, the company derives maximum revenue from the domestic market and also exports its products to other regions.
49GF Score
Get the complete analysis for BKK:UEC-R
Debt-to-EBITDA is just one metric. See GF Value™, 30-year financials, guru trades, warning signs, and more.
Quick Browse
Personalize
Premium Gurus 
Create New Portfolio
BKK:UEC-R has been successfully added to your 
