* The 5-Year EBITDA Growth Rate is the 5-year average EBITDA per share growth rate. While the denominator is a percentage, we use the whole number as opposed to the decimal form for the calculation. For example, 5% would be shown as 5 as opposed to 0.05. If it's smaller than or equal to 0, then the PEG Ratio is not calculated.
The historical rank and industry rank for Priner Servicos Industriais's PEG Ratio or its related term are showing as below:
BSP:PRNR3'
s PEG Ratio Range Over the Past 10 Years
Min: 0.24 Med: 0.92 Max: 3.37
Current: 0.95
During the past 10 years, Priner Servicos Industriais's highest PEG Ratio was 3.37. The lowest was 0.24. And the median was 0.92.
BSP:PRNR3's PEG Ratio is ranked better than 55.78% of 683
companies
in the Construction industry
Industry Median: 1.12
vs BSP:PRNR3: 0.95
Peter Lynch thinks a company with a P/E ratio equal to its growth rate is fairly valued.
Priner Servicos Industriais (BSP:PRNR3) PEG Ratio Explanation
To compare stocks with different growth rates, Peter Lynch invented a ratio called PEG Ratio. PEG Ratio is defined as the P/E ratio divided by the growth ratio. He thinks a company with a P/E ratio equal to its growth rate is fairly valued. Still he said he would rather buy a company growing 20% a year with a P/E of 20, instead of a company growing 10% a year with a P/E of 10.
Priner Servicos Industriais PEG Ratio Related Terms
Priner Servicos Industriais PEG Ratio Historical Data
* For Operating Data section: All numbers are indicated by the unit behind each term and all currency related amount are in USD. * For other sections: All numbers are in millions except for per share data, ratio, and percentage. All currency related amount are indicated in the company's associated stock exchange currency.
For the Engineering & Construction subindustry, Priner Servicos Industriais's PEG Ratio, along with its competitors' market caps and PEG Ratio data, can be viewed below:
* Competitive companies are chosen from companies within the same industry, with headquarter located in same country, with closest market capitalization; x-axis shows the market cap, and y-axis shows the term value; the bigger the dot, the larger the market cap. Note that "N/A" values will not show up in the chart.
Priner Servicos Industriais PEG Ratio vs Construction Industry
For the Construction industry and Industrials sector, Priner Servicos Industriais's PEG Ratio distribution charts can be found below:
* The bar in red indicates where Priner Servicos Industriais's PEG Ratio falls into.
* For Operating Data section: All numbers are indicated by the unit behind each term and all currency related amount are in USD. * For other sections: All numbers are in millions except for per share data, ratio, and percentage. All currency related amount are indicated in the company's associated stock exchange currency.
* Note: The 5-Year EBITDA Growth Rate is the 5-year average EBITDA per share growth rate. While the denominator is a percentage, we use the whole number as opposed to the decimal form for the calculation. For example, 5% would be shown as 5 as opposed to 0.05. If it's smaller than or equal to 0, then the PEG Ratio is not calculated.
Priner Servicos Industriais (BSP:PRNR3) has a PEG Ratio of 0.95 as of Jul. 07, 2026. Price-earnings to growth ratio is the ratio of price-earnings to a company's earnings growth rate. View historical data on Priner Servicos Industriais and its competitors. This is near median its historical median of 0.92. Over the past decade, Priner Servicos Industriais' PEG Ratio has ranged from 0.24 to 3.37. According to the industry distribution chart, Priner Servicos Industriais ranks #302 out of 683 companies in the Construction industry, placing it in the top 44.2%.
Is Priner Servicos Industriais' PEG Ratio too high?
Priner Servicos Industriais' current PEG Ratio of 0.95 is near median its 10-year median of 0.92. Over the past 10 years, this metric has ranged from a low of 0.24 to a high of 3.37. The Construction industry median PEG Ratio is 1.12. Priner Servicos Industriais' value of 0.95 is 15.2% below this industry median. Based on the distribution chart, Priner Servicos Industriais ranks #302 out of 683 companies in the Construction industry, which is above the industry midpoint. Overall, Priner Servicos Industriais has a GF Score™ of 85/100 and is considered Modestly Overvalued, reflecting its overall financial health beyond just this single metric.
How does Priner Servicos Industriais' PEG Ratio compare to PWR and FIX?
According to the Construction industry distribution chart, Priner Servicos Industriais ranks #302 out of 683 companies for PEG Ratio. This puts Priner Servicos Industriais in the upper half of its industry. The industry median PEG Ratio is 1.12. Priner Servicos Industriais' value of 0.95 is 15.2% below this benchmark. Historically, Priner Servicos Industriais' own PEG Ratio has ranged from 0.24 to 3.37 over the past decade. While the company's 10-year median is 0.92 vs. the industry median of 1.12, Priner Servicos Industriais has consistently been below the industry average. See the competitive comparison table and distribution chart on this page for a detailed peer-by-peer breakdown.
What is a good PEG Ratio for a Construction company?
The median PEG Ratio among Construction companies is 1.12, based on 683 companies in the industry. Companies in the top quartile (top 25%) have a PEG Ratio significantly above this median, while those in the bottom quartile fall well below. However, PEG Ratio should not be evaluated in isolation — investors should consider it alongside profitability, growth, and financial strength metrics. Priner Servicos Industriais's current PEG Ratio of 0.95 is 15.2% below the industry median. Use the industry distribution chart on this page to see where any company falls relative to its peers.
What does a high PEG Ratio mean?
A high PEG Ratio can signal that a stock is expensive relative to its fundamentals. Price-earnings to growth ratio is the ratio of price-earnings to a company's earnings growth rate. View historical data on Priner Servicos Industriais and its competitors. For the Construction industry, the median PEG Ratio is 1.12 — values significantly above this may indicate overvaluation, while values below may suggest a bargain or underlying issues. Priner Servicos Industriais's current PEG Ratio is 0.95, which is near median its own 10-year median of 0.92. However, context matters — high-growth companies often justify higher valuations. Always evaluate alongside other metrics like GF Score™ and GF Value™.
Is Priner Servicos Industriais stock overvalued right now?
Based on GuruFocus' analysis, Priner Servicos Industriais (BSP:PRNR3) is currently considered Modestly Overvalued. The stock's GF Value™ is R$16.37, compared to a current price of R$18.46 — trading 12.8% above its estimated fair value. The current PEG Ratio is 0.95, which is near median its 10-year median of 0.92 and 15.2% below the Construction industry median of 1.12. Priner Servicos Industriais' overall GF Score™ is 85/100 with 5 warning signs to review. Investors should evaluate multiple metrics — including profitability, growth, and financial strength — before making a decision.
How is PEG Ratio calculated?
PEG Ratio is calculated from a company's financial statements. For Priner Servicos Industriais (BSP:PRNR3), the current PEG Ratio is 0.95 as of Jul. 07, 2026. GuruFocus calculates this using data sourced from SEC filings and annual reports. See the calculation section and 30-year financial data on this page for the full breakdown.
Is Priner Servicos Industriais (BSP:PRNR3) Overvalued in 2026?
Based on GuruFocus' analysis, Priner Servicos Industriais stock appears to be overvalued.
The current stock price of R$18.46 is trading 12.8% above its estimated GF Value™ of R$16.37.
GuruFocus considers Priner Servicos Industriais to be Modestly Overvalued.
Key valuation signals for BSP:PRNR3:
PEG Ratio: 0.95 (near median its 10-year median of 0.92)
GF Value™: R$16.37 vs. price of R$18.46 (12.8% above fair value)
Industry Position: 15.2% below the Construction median (#302 of 683)
No single metric tells the full story. See the BSP:PRNR3 stock analysis page for a complete view including 30-year financials, guru trades, and insider activity.
Priner Servicos Industriais SA provides diversified services like industrial painting, surface treatment, thermal insulation and pressurized habitat. Priner operates throughout Brazil providing services in the areas of Petrochemical, Pulp, and Paper, Steel, Offshore, Naval, and Mining.
85GF Score
Get the complete analysis for BSP:PRNR3
PEG Ratio is just one metric. See GF Value™, 30-year financials, guru trades, warning signs, and more.
Quick Browse
Personalize
Premium Gurus 
Create New Portfolio
BSP:PRNR3 has been successfully added to your 
