* The 5-Year EBITDA Growth Rate is the 5-year average EBITDA per share growth rate. While the denominator is a percentage, we use the whole number as opposed to the decimal form for the calculation. For example, 5% would be shown as 5 as opposed to 0.05. If it's smaller than or equal to 0, then the PEG Ratio is not calculated.
The historical rank and industry rank for Johnson Controls International's PEG Ratio or its related term are showing as below:
FRA:TYIA'
s PEG Ratio Range Over the Past 10 Years
Min: 1.3 Med: 5.38 Max: 14.56
Current: 4.71
During the past 13 years, Johnson Controls International's highest PEG Ratio was 14.56. The lowest was 1.30. And the median was 5.38.
FRA:TYIA's PEG Ratio is ranked worse than 84.69% of 686
companies
in the Construction industry
Industry Median: 1.105
vs FRA:TYIA: 4.71
Peter Lynch thinks a company with a P/E ratio equal to its growth rate is fairly valued.
Johnson Controls International (FRA:TYIA) PEG Ratio Explanation
To compare stocks with different growth rates, Peter Lynch invented a ratio called PEG Ratio. PEG Ratio is defined as the P/E ratio divided by the growth ratio. He thinks a company with a P/E ratio equal to its growth rate is fairly valued. Still he said he would rather buy a company growing 20% a year with a P/E of 20, instead of a company growing 10% a year with a P/E of 10.
Johnson Controls International PEG Ratio Related Terms
Johnson Controls International PEG Ratio Historical Data
* For Operating Data section: All numbers are indicated by the unit behind each term and all currency related amount are in USD. * For other sections: All numbers are in millions except for per share data, ratio, and percentage. All currency related amount are indicated in the company's associated stock exchange currency.
For the Building Products & Equipment subindustry, Johnson Controls International's PEG Ratio, along with its competitors' market caps and PEG Ratio data, can be viewed below:
* Competitive companies are chosen from companies within the same industry, with headquarter located in same country, with closest market capitalization; x-axis shows the market cap, and y-axis shows the term value; the bigger the dot, the larger the market cap. Note that "N/A" values will not show up in the chart.
Johnson Controls International PEG Ratio vs Construction Industry
For the Construction industry and Industrials sector, Johnson Controls International's PEG Ratio distribution charts can be found below:
* The bar in red indicates where Johnson Controls International's PEG Ratio falls into.
* For Operating Data section: All numbers are indicated by the unit behind each term and all currency related amount are in USD. * For other sections: All numbers are in millions except for per share data, ratio, and percentage. All currency related amount are indicated in the company's associated stock exchange currency.
* Note: The 5-Year EBITDA Growth Rate is the 5-year average EBITDA per share growth rate. While the denominator is a percentage, we use the whole number as opposed to the decimal form for the calculation. For example, 5% would be shown as 5 as opposed to 0.05. If it's smaller than or equal to 0, then the PEG Ratio is not calculated.
Johnson Controls International (FRA:TYIA) has a PEG Ratio of 4.82 as of Jun. 29, 2026. Price-earnings to growth ratio is the ratio of price-earnings to a company's earnings growth rate. View historical data on Johnson Controls International and its competitors. This is 10% below median its historical median of 5.38. Over the past decade, Johnson Controls International's PEG Ratio has ranged from 1.30 to 14.56. According to the industry distribution chart, Johnson Controls International ranks #581 out of 686 companies in the Construction industry, placing it in the top 84.7%.
Is Johnson Controls International's PEG Ratio too high?
Johnson Controls International's current PEG Ratio of 4.82 is 10% below median its 10-year median of 5.38. Over the past 10 years, this metric has ranged from a low of 1.30 to a high of 14.56. The Construction industry median PEG Ratio is 1.11. Johnson Controls International's value of 4.82 is 336.2% above this industry median. Based on the distribution chart, Johnson Controls International ranks #581 out of 686 companies in the Construction industry, which is in the bottom quartile relative to peers. Overall, Johnson Controls International has a GF Score™ of 76/100 and is considered Significantly Overvalued, reflecting its overall financial health beyond just this single metric.
How does Johnson Controls International's PEG Ratio compare to TT and CARR?
According to the Construction industry distribution chart, Johnson Controls International ranks #581 out of 686 companies for PEG Ratio. This places Johnson Controls International in the lower half of its industry. The industry median PEG Ratio is 1.11. Johnson Controls International's value of 4.82 is 336.2% above this benchmark. Historically, Johnson Controls International's own PEG Ratio has ranged from 1.30 to 14.56 over the past decade. While the company's 10-year median is 5.38 vs. the industry median of 1.11, Johnson Controls International has consistently been above the industry average. See the competitive comparison table and distribution chart on this page for a detailed peer-by-peer breakdown.
What is a good PEG Ratio for a Construction company?
The median PEG Ratio among Construction companies is 1.11, based on 686 companies in the industry. Companies in the top quartile (top 25%) have a PEG Ratio significantly above this median, while those in the bottom quartile fall well below. However, PEG Ratio should not be evaluated in isolation — investors should consider it alongside profitability, growth, and financial strength metrics. Johnson Controls International's current PEG Ratio of 4.82 is 336.2% above the industry median. Use the industry distribution chart on this page to see where any company falls relative to its peers.
What does a high PEG Ratio mean?
A high PEG Ratio can signal that a stock is expensive relative to its fundamentals. Price-earnings to growth ratio is the ratio of price-earnings to a company's earnings growth rate. View historical data on Johnson Controls International and its competitors. For the Construction industry, the median PEG Ratio is 1.11 — values significantly above this may indicate overvaluation, while values below may suggest a bargain or underlying issues. Johnson Controls International's current PEG Ratio is 4.82, which is 10% below median its own 10-year median of 5.38. However, context matters — high-growth companies often justify higher valuations. Always evaluate alongside other metrics like GF Score™ and GF Value™.
Is Johnson Controls International stock overvalued right now?
Based on GuruFocus' analysis, Johnson Controls International (FRA:TYIA) is currently considered Significantly Overvalued. The stock's GF Value™ is €84.47, compared to a current price of €121.80 — trading 44.2% above its estimated fair value. The current PEG Ratio is 4.82, which is 10% below median its 10-year median of 5.38 and 336.2% above the Construction industry median of 1.11. Johnson Controls International's overall GF Score™ is 76/100 with 7 warning signs to review. Investors should evaluate multiple metrics — including profitability, growth, and financial strength — before making a decision.
How is PEG Ratio calculated?
PEG Ratio is calculated from a company's financial statements. For Johnson Controls International (FRA:TYIA), the current PEG Ratio is 4.82 as of Jun. 29, 2026. GuruFocus calculates this using data sourced from SEC filings and annual reports. See the calculation section and 30-year financial data on this page for the full breakdown.
Is Johnson Controls International (FRA:TYIA) Overvalued in 2026?
Based on GuruFocus' analysis, Johnson Controls International stock appears to be overvalued.
The current stock price of €121.80 is trading 44.2% above its estimated GF Value™ of €84.47.
GuruFocus considers Johnson Controls International to be Significantly Overvalued.
Key valuation signals for FRA:TYIA:
PEG Ratio: 4.82 (10% below median its 10-year median of 5.38)
GF Value™: €84.47 vs. price of €121.80 (44.2% above fair value)
Industry Position: 336.2% above the Construction median (#581 of 686)
No single metric tells the full story. See the FRA:TYIA stock analysis page for a complete view including 30-year financials, guru trades, and insider activity.
Johnson Controls International Business Description
Following Johnson Controls' divestiture of its residential and light commercial HVAC businesses to Bosch in 2025, nearly all of its revenue comes from commercial HVAC (60%) and fire and security products and services (40%). A 2016 merger joined Johnson Controls' HVAC and Tyco's fire and security businesses with the premise that there is synergy in offering a broader variety of automation products and solutions to commercial buildings. We estimate Johnson Controls' pro forma revenue mix will be one-third products, one-third installation, and one-third services.
76GF Score
Get the complete analysis for FRA:TYIA
PEG Ratio is just one metric. See GF Value™, 30-year financials, guru trades, warning signs, and more.
Quick Browse
Personalize
Premium Gurus 
Create New Portfolio
FRA:TYIA has been successfully added to your 
