* The 5-Year EBITDA Growth Rate is the 5-year average EBITDA per share growth rate. While the denominator is a percentage, we use the whole number as opposed to the decimal form for the calculation. For example, 5% would be shown as 5 as opposed to 0.05. If it's smaller than or equal to 0, then the PEG Ratio is not calculated.
The historical rank and industry rank for Fortune Brands Innovations's PEG Ratio or its related term are showing as below:
MEX:FBIN'
s PEG Ratio Range Over the Past 10 Years
Min: 0.36 Med: 1.63 Max: 19.27
Current: 14.53
During the past 13 years, Fortune Brands Innovations's highest PEG Ratio was 19.27. The lowest was 0.36. And the median was 1.63.
MEX:FBIN's PEG Ratio is ranked worse than 94.58% of 683
companies
in the Construction industry
Industry Median: 1.13
vs MEX:FBIN: 14.53
Peter Lynch thinks a company with a P/E ratio equal to its growth rate is fairly valued.
Fortune Brands Innovations (MEX:FBIN) PEG Ratio Explanation
To compare stocks with different growth rates, Peter Lynch invented a ratio called PEG Ratio. PEG Ratio is defined as the P/E ratio divided by the growth ratio. He thinks a company with a P/E ratio equal to its growth rate is fairly valued. Still he said he would rather buy a company growing 20% a year with a P/E of 20, instead of a company growing 10% a year with a P/E of 10.
Fortune Brands Innovations PEG Ratio Related Terms
Fortune Brands Innovations PEG Ratio Historical Data
* For Operating Data section: All numbers are indicated by the unit behind each term and all currency related amount are in USD. * For other sections: All numbers are in millions except for per share data, ratio, and percentage. All currency related amount are indicated in the company's associated stock exchange currency.
For the Building Products & Equipment subindustry, Fortune Brands Innovations's PEG Ratio, along with its competitors' market caps and PEG Ratio data, can be viewed below:
* Competitive companies are chosen from companies within the same industry, with headquarter located in same country, with closest market capitalization; x-axis shows the market cap, and y-axis shows the term value; the bigger the dot, the larger the market cap. Note that "N/A" values will not show up in the chart.
Fortune Brands Innovations PEG Ratio vs Construction Industry
For the Construction industry and Industrials sector, Fortune Brands Innovations's PEG Ratio distribution charts can be found below:
* The bar in red indicates where Fortune Brands Innovations's PEG Ratio falls into.
* For Operating Data section: All numbers are indicated by the unit behind each term and all currency related amount are in USD. * For other sections: All numbers are in millions except for per share data, ratio, and percentage. All currency related amount are indicated in the company's associated stock exchange currency.
* Note: The 5-Year EBITDA Growth Rate is the 5-year average EBITDA per share growth rate. While the denominator is a percentage, we use the whole number as opposed to the decimal form for the calculation. For example, 5% would be shown as 5 as opposed to 0.05. If it's smaller than or equal to 0, then the PEG Ratio is not calculated.
Fortune Brands Innovations (MEX:FBIN) has a PEG Ratio of 23.38 as of Jul. 06, 2026. Price-earnings to growth ratio is the ratio of price-earnings to a company's earnings growth rate. View historical data on Fortune Brands Innovations and its competitors. This is 1334% above median its historical median of 1.63. Over the past decade, Fortune Brands Innovations' PEG Ratio has ranged from 0.36 to 19.27. According to the industry distribution chart, Fortune Brands Innovations ranks #646 out of 683 companies in the Construction industry, placing it in the top 94.6%.
Is Fortune Brands Innovations' PEG Ratio too high?
Fortune Brands Innovations' current PEG Ratio of 23.38 is 1334% above median its 10-year median of 1.63. Over the past 10 years, this metric has ranged from a low of 0.36 to a high of 19.27. The Construction industry median PEG Ratio is 1.13. Fortune Brands Innovations' value of 23.38 is 1969% above this industry median. Based on the distribution chart, Fortune Brands Innovations ranks #646 out of 683 companies in the Construction industry, which is in the bottom quartile relative to peers. Overall, Fortune Brands Innovations has a GF Score™ of 74/100, reflecting its overall financial health beyond just this single metric.
How does Fortune Brands Innovations' PEG Ratio compare to LPX and TREX?
According to the Construction industry distribution chart, Fortune Brands Innovations ranks #646 out of 683 companies for PEG Ratio. This places Fortune Brands Innovations in the lower half of its industry. The industry median PEG Ratio is 1.13. Fortune Brands Innovations' value of 23.38 is 1969% above this benchmark. Historically, Fortune Brands Innovations' own PEG Ratio has ranged from 0.36 to 19.27 over the past decade. While the company's 10-year median is 1.63 vs. the industry median of 1.13, Fortune Brands Innovations has consistently been above the industry average. See the competitive comparison table and distribution chart on this page for a detailed peer-by-peer breakdown.
What is a good PEG Ratio for a Construction company?
The median PEG Ratio among Construction companies is 1.13, based on 683 companies in the industry. Companies in the top quartile (top 25%) have a PEG Ratio significantly above this median, while those in the bottom quartile fall well below. However, PEG Ratio should not be evaluated in isolation — investors should consider it alongside profitability, growth, and financial strength metrics. Fortune Brands Innovations's current PEG Ratio of 23.38 is 1969% above the industry median. Use the industry distribution chart on this page to see where any company falls relative to its peers.
What does a high PEG Ratio mean?
A high PEG Ratio can signal that a stock is expensive relative to its fundamentals. Price-earnings to growth ratio is the ratio of price-earnings to a company's earnings growth rate. View historical data on Fortune Brands Innovations and its competitors. For the Construction industry, the median PEG Ratio is 1.13 — values significantly above this may indicate overvaluation, while values below may suggest a bargain or underlying issues. Fortune Brands Innovations's current PEG Ratio is 23.38, which is 1334% above median its own 10-year median of 1.63. However, context matters — high-growth companies often justify higher valuations. Always evaluate alongside other metrics like GF Score™ and GF Value™.
Is Fortune Brands Innovations stock overvalued right now?
Fortune Brands Innovations (MEX:FBIN) has a current PEG Ratio of 23.38. The stock's GF Value™ is MXN1,977.48, compared to a current price of MXN1,575.00 — trading 20.4% below its estimated fair value. The current PEG Ratio is 23.38, which is 1334% above median its 10-year median of 1.63 and 1969% above the Construction industry median of 1.13. Fortune Brands Innovations' overall GF Score™ is 74/100 with 5 warning signs to review. Investors should evaluate multiple metrics — including profitability, growth, and financial strength — before making a decision.
How is PEG Ratio calculated?
PEG Ratio is calculated from a company's financial statements. For Fortune Brands Innovations (MEX:FBIN), the current PEG Ratio is 23.38 as of Jul. 06, 2026. GuruFocus calculates this using data sourced from SEC filings and annual reports. See the calculation section and 30-year financial data on this page for the full breakdown.
Is Fortune Brands Innovations (MEX:FBIN) Overvalued in 2026?
Based on GuruFocus' analysis, Fortune Brands Innovations stock appears to be undervalued.
The current stock price of MXN1,575.00 is trading 20.4% below its estimated GF Value™ of MXN1,977.48.
Key valuation signals for MEX:FBIN:
PEG Ratio: 23.38 (1334% above median its 10-year median of 1.63)
GF Value™: MXN1,977.48 vs. price of MXN1,575.00 (20.4% below fair value)
Industry Position: 1969% above the Construction median (#646 of 683)
No single metric tells the full story. See the MEX:FBIN stock analysis page for a complete view including 30-year financials, guru trades, and insider activity.
Fortune Brands is a US-based homebuilding products company that sells building-related products serving R&R and new construction markets. The company operates in three segments: water, outdoors, and security. Water innovation, including plumbing fixtures and faucets, accounts for around 55% of total sales and features brands such as Moen, House of Rohl, and Aqualisa. The outdoors segment includes decking, railing, and doors and makes up 30% of total sales, featuring brands such as Larson, Fiberon, and Therma-Tru. The security segment, which includes smart residential padlocks, accounts for the remaining 15% of sales and features brands such as MasterLock, SentrySafe, Yale, and AmericanLock.
74GF Score
Get the complete analysis for MEX:FBIN
PEG Ratio is just one metric. See GF Value™, 30-year financials, guru trades, warning signs, and more.
Quick Browse
Personalize
Premium Gurus 
Create New Portfolio
MEX:FBIN has been successfully added to your 
