STP&I PCL (BKK:STPI-R) 5-Year Yield-on-Cost %: 0.00 (As of Jun. 24, 2026)


What is STP&I PCL 5-Year Yield-on-Cost %?

STP&I PCL BKK:STPI-R 60 5-Year Yield-on-Cost % is 0.00 as of Jun. 24, 2026. GuruFocus rates BKK:STPI-R with a GF Score™ of 60/100. The stock has 4 warning signs investors should review. Among 1,927 Industrial Products companies, STP&I PCL ranks worse than 51894.08% on this metric.

STP&I PCL's yield on cost for the quarter that ended in Mar. 2026 was 0.00.


The historical rank and industry rank for STP&I PCL's 5-Year Yield-on-Cost % or its related term are showing as below:


During the past 13 years, STP&I PCL's highest Yield on Cost was 11.18. The lowest was 1.29. And the median was 4.38.


BKK:STPI-R's 5-Year Yield-on-Cost % is not ranked *
in the Industrial Products industry.
Industry Median: 1.74
* Ranked among companies with meaningful 5-Year Yield-on-Cost % only.

STP&I PCL  (BKK:STPI-R) 5-Year Yield-on-Cost % Explanation

Of course the risk here is that the company may not raise its dividends as it did before. The key is to select the companies that can consistently raise its dividends. Usually companies with long history of raising dividends tend to do so.

STP&I PCL 5-Year Yield-on-Cost % Related Terms

BKK:STPI-R vs ATI, CRS, MLI: 5-Year Yield-on-Cost % Comparison

For the Metal Fabrication subindustry, STP&I PCL's 5-Year Yield-on-Cost %, along with its competitors' market caps and 5-Year Yield-on-Cost % data, can be viewed below:

* Competitive companies are chosen from companies within the same industry, with headquarter located in same country, with closest market capitalization; x-axis shows the market cap, and y-axis shows the term value; the bigger the dot, the larger the market cap. Note that "N/A" values will not show up in the chart.

STP&I PCL 5-Year Yield-on-Cost % vs Industrial Products Industry

For the Industrial Products industry and Industrials sector, STP&I PCL's 5-Year Yield-on-Cost % distribution charts can be found below:

* The bar in red indicates where STP&I PCL's 5-Year Yield-on-Cost % falls into.


STP&I PCL 5-Year Yield-on-Cost % Calculation

Dividend Yield % and dividend growth of a stock is an important factor for income investors. But if company A raises its dividend constantly faster than company B, company A's future dividend yield might be much higher than Company B's even if their yields are the same now and their stock prices do not change.

Yield on Cost assumes that you buy and the stock today, and hold it for 5 years. If the company raises it dividends at the same rate as it did over the past 5 years, the dividends investors receive annually in 5 years relative to the stock price today.

Therefore, Yield-on-Cost of STP&I PCL is calculated as

Yield-on-Cost=Dividend Yield %*(1+Dividend Growth Rate)^5
Frequently Asked Questions Learn more about 5-Year Yield-on-Cost % →
What does a 5-Year Yield-on-Cost % of 0.00 mean?
STP&I PCL (BKK:STPI-R) has a 5-Year Yield-on-Cost % of 0.00 as of Jun. 24, 2026. 5-Year Yield on Cost measures the expected yield based on a company's current yield and 5-year dividend growth. View historical data on STP&I PCL and its competitors. Over the past decade, STP&I PCL's 5-Year Yield-on-Cost % has ranged from 1.29 to 11.18. According to the industry distribution chart, STP&I PCL ranks #999999 out of 1927 companies in the Industrial Products industry.
Is STP&I PCL's 5-Year Yield-on-Cost % too high?
STP&I PCL's current 5-Year Yield-on-Cost % is 0.00. Over the past 10 years, this metric has ranged from a low of 1.29 to a high of 11.18. Based on the distribution chart, STP&I PCL ranks #999999 out of 1927 companies in the Industrial Products industry, which is in the bottom quartile relative to peers. Overall, STP&I PCL has a GF Score™ of 60/100, reflecting its overall financial health beyond just this single metric.
How does STP&I PCL's 5-Year Yield-on-Cost % compare to ATI and CRS?
According to the Industrial Products industry distribution chart, STP&I PCL ranks #999999 out of 1927 companies for 5-Year Yield-on-Cost %. This places STP&I PCL in the lower half of its industry. The industry median 5-Year Yield-on-Cost % is 1.74. Historically, STP&I PCL's own 5-Year Yield-on-Cost % has ranged from 1.29 to 11.18 over the past decade. See the competitive comparison table and distribution chart on this page for a detailed peer-by-peer breakdown.
What is a good 5-Year Yield-on-Cost % for an Industrial Products company?
The median 5-Year Yield-on-Cost % among Industrial Products companies is 1.74, based on 1,927 companies in the industry. Companies in the top quartile (top 25%) have a 5-Year Yield-on-Cost % significantly above this median, while those in the bottom quartile fall well below. However, 5-Year Yield-on-Cost % should not be evaluated in isolation — investors should consider it alongside profitability, growth, and financial strength metrics. Use the industry distribution chart on this page to see where any company falls relative to its peers.
What does a high 5-Year Yield-on-Cost % mean?
A high 5-Year Yield-on-Cost % can signal that a stock is expensive relative to its fundamentals. 5-Year Yield on Cost measures the expected yield based on a company's current yield and 5-year dividend growth. View historical data on STP&I PCL and its competitors. For the Industrial Products industry, the median 5-Year Yield-on-Cost % is 1.74 — values significantly above this may indicate overvaluation, while values below may suggest a bargain or underlying issues. STP&I PCL's current 5-Year Yield-on-Cost % is 0.00. However, context matters — high-growth companies often justify higher valuations. Always evaluate alongside other metrics like GF Score™ and GF Value™.
Is STP&I PCL stock overvalued right now?
STP&I PCL (BKK:STPI-R) has a current 5-Year Yield-on-Cost % of 0.00. The current 5-Year Yield-on-Cost % is 0.00. STP&I PCL's overall GF Score™ is 60/100 with 4 warning signs to review. Investors should evaluate multiple metrics — including profitability, growth, and financial strength — before making a decision.
How is 5-Year Yield-on-Cost % calculated?
5-Year Yield-on-Cost % is calculated from a company's financial statements. For STP&I PCL (BKK:STPI-R), the current 5-Year Yield-on-Cost % is 0.00 as of Jun. 24, 2026. GuruFocus calculates this using data sourced from SEC filings and annual reports. See the calculation section and 30-year financial data on this page for the full breakdown.

STP&I PCL Business Description

Other Exchanges STPI:Thailand
Address Sukhumvit 21 Road (Asoke), 32/24, 3rd Floor, Sino-Thai Tower, Kwaeng Klongtoey Nua, Khet Wattana, Bangkok, THA, 10110
STP&I PCL is engaged in steel fabrication work, and the manufacture of boilers and pressure vessels. Its products include Steel structure, Piping, Module providing services to engineering, fabrication and construction sectors. The company operates in five reportable segments namely, The fabrication work for construction and industrial purpose, Sale of electricity and servicing of electricity, Rental of property, and production and Distribution of hemp products. It has a business presence in Thailand, Spain, Japan, England, Sri Lanka and other countries.