M.C.S. Steel PCLBKK:MCS 68 5-Year Yield-on-Cost % is 6.77 as of Jul. 11, 2026, which is 77% above its 10-year median of 3.83. GuruFocus rates BKK:MCS with a GF Score™ of 68/100 and a GF Value™ of ฿6.53 (Modestly Overvalued). The stock has 5 warning signs investors should review. Among 318 Steel companies, M.C.S. Steel PCL ranks better than 72.33% on this metric.
M.C.S. Steel PCL's yield on cost for the quarter that ended in Mar. 2026 was 6.77.
The historical rank and industry rank for M.C.S. Steel PCL's 5-Year Yield-on-Cost % or its related term are showing as below:
BKK:MCS'
s 5-Year Yield-on-Cost % Range Over the Past 10 Years
Min: 1.18 Med: 3.83 Max: 7.47
Current: 6.77
During the past 13 years, M.C.S. Steel PCL's highest Yield on Cost was 7.47. The lowest was 1.18. And the median was 3.83.
BKK:MCS's 5-Year Yield-on-Cost % is ranked better than 72.33% of 318
companies
in the Steel industry
Industry Median: 3.36
vs BKK:MCS: 6.77
Of course the risk here is that the company may not raise its dividends as it did before. The key is to select the companies that can consistently raise its dividends. Usually companies with long history of raising dividends tend to do so.
M.C.S. Steel PCL 5-Year Yield-on-Cost % Related Terms
BKK:MCS vs NUE, STLD, RS: 5-Year Yield-on-Cost % Comparison
For the Steel subindustry, M.C.S. Steel PCL's 5-Year Yield-on-Cost %, along with its competitors' market caps and 5-Year Yield-on-Cost % data, can be viewed below:
* Competitive companies are chosen from companies within the same industry, with headquarter located in same country, with closest market capitalization; x-axis shows the market cap, and y-axis shows the term value; the bigger the dot, the larger the market cap. Note that "N/A" values will not show up in the chart.
M.C.S. Steel PCL 5-Year Yield-on-Cost % vs Steel Industry
For the Steel industry and Basic Materials sector, M.C.S. Steel PCL's 5-Year Yield-on-Cost % distribution charts can be found below:
* The bar in red indicates where M.C.S. Steel PCL's 5-Year Yield-on-Cost % falls into.
Dividend Yield % and dividend growth of a stock is an important factor for income investors. But if company A raises its dividend constantly faster than company B, company A's future dividend yield might be much higher than Company B's even if their yields are the same now and their stock prices do not change.
Yield on Cost assumes that you buy and the stock today, and hold it for 5 years. If the company raises it dividends at the same rate as it did over the past 5 years, the dividends investors receive annually in 5 years relative to the stock price today.
M.C.S. Steel PCL (BKK:MCS) has a 5-Year Yield-on-Cost % of 6.77 as of Jul. 11, 2026. 5-Year Yield on Cost measures the expected yield based on a company's current yield and 5-year dividend growth. View historical data on M.C.S. Steel PCL and its competitors. This is 77% above median its historical median of 3.83. Over the past decade, M.C.S. Steel PCL's 5-Year Yield-on-Cost % has ranged from 1.18 to 7.47. According to the industry distribution chart, M.C.S. Steel PCL ranks #88 out of 318 companies in the Steel industry, placing it in the top 27.7%.
Is M.C.S. Steel PCL's 5-Year Yield-on-Cost % too high?
M.C.S. Steel PCL's current 5-Year Yield-on-Cost % of 6.77 is 77% above median its 10-year median of 3.83. Over the past 10 years, this metric has ranged from a low of 1.18 to a high of 7.47. The Steel industry median 5-Year Yield-on-Cost % is 3.36. M.C.S. Steel PCL's value of 6.77 is 101.5% above this industry median. Based on the distribution chart, M.C.S. Steel PCL ranks #88 out of 318 companies in the Steel industry, which is above the industry midpoint. Overall, M.C.S. Steel PCL has a GF Score™ of 68/100 and is considered Modestly Overvalued, reflecting its overall financial health beyond just this single metric.
How does M.C.S. Steel PCL's 5-Year Yield-on-Cost % compare to NUE and STLD?
According to the Steel industry distribution chart, M.C.S. Steel PCL ranks #88 out of 318 companies for 5-Year Yield-on-Cost %. This puts M.C.S. Steel PCL in the upper half of its industry. The industry median 5-Year Yield-on-Cost % is 3.36. M.C.S. Steel PCL's value of 6.77 is 101.5% above this benchmark. Historically, M.C.S. Steel PCL's own 5-Year Yield-on-Cost % has ranged from 1.18 to 7.47 over the past decade. While the company's 10-year median is 3.83 vs. the industry median of 3.36, M.C.S. Steel PCL has consistently been above the industry average. See the competitive comparison table and distribution chart on this page for a detailed peer-by-peer breakdown.
What is a good 5-Year Yield-on-Cost % for a Steel company?
The median 5-Year Yield-on-Cost % among Steel companies is 3.36, based on 318 companies in the industry. Companies in the top quartile (top 25%) have a 5-Year Yield-on-Cost % significantly above this median, while those in the bottom quartile fall well below. However, 5-Year Yield-on-Cost % should not be evaluated in isolation — investors should consider it alongside profitability, growth, and financial strength metrics. M.C.S. Steel PCL's current 5-Year Yield-on-Cost % of 6.77 is 101.5% above the industry median. Use the industry distribution chart on this page to see where any company falls relative to its peers.
What does a high 5-Year Yield-on-Cost % mean?
A high 5-Year Yield-on-Cost % can signal that a stock is expensive relative to its fundamentals. 5-Year Yield on Cost measures the expected yield based on a company's current yield and 5-year dividend growth. View historical data on M.C.S. Steel PCL and its competitors. For the Steel industry, the median 5-Year Yield-on-Cost % is 3.36 — values significantly above this may indicate overvaluation, while values below may suggest a bargain or underlying issues. M.C.S. Steel PCL's current 5-Year Yield-on-Cost % is 6.77, which is 77% above median its own 10-year median of 3.83. However, context matters — high-growth companies often justify higher valuations. Always evaluate alongside other metrics like GF Score™ and GF Value™.
Is M.C.S. Steel PCL stock overvalued right now?
Based on GuruFocus' analysis, M.C.S. Steel PCL (BKK:MCS) is currently considered Modestly Overvalued. The stock's GF Value™ is ฿6.53, compared to a current price of ฿7.85 — trading 20.2% above its estimated fair value. The current 5-Year Yield-on-Cost % is 6.77, which is 77% above median its 10-year median of 3.83 and 101.5% above the Steel industry median of 3.36. M.C.S. Steel PCL's overall GF Score™ is 68/100 with 5 warning signs to review. Investors should evaluate multiple metrics — including profitability, growth, and financial strength — before making a decision.
How is 5-Year Yield-on-Cost % calculated?
5-Year Yield-on-Cost % is calculated from a company's financial statements. For M.C.S. Steel PCL (BKK:MCS), the current 5-Year Yield-on-Cost % is 6.77 as of Jul. 11, 2026. GuruFocus calculates this using data sourced from SEC filings and annual reports. See the calculation section and 30-year financial data on this page for the full breakdown.
Is M.C.S. Steel PCL (BKK:MCS) Overvalued in 2026?
Based on GuruFocus' analysis, M.C.S. Steel PCL stock appears to be overvalued.
The current stock price of ฿7.85 is trading 20.2% above its estimated GF Value™ of ฿6.53.
GuruFocus considers M.C.S. Steel PCL to be Modestly Overvalued.
Key valuation signals for BKK:MCS:
5-Year Yield-on-Cost %: 6.77 (77% above median its 10-year median of 3.83)
GF Value™: ฿6.53 vs. price of ฿7.85 (20.2% above fair value)
Industry Position: 101.5% above the Steel median (#88 of 318)
No single metric tells the full story. See the BKK:MCS stock analysis page for a complete view including 30-year financials, guru trades, and insider activity.
M.C.S. Steel PCL is engaged in the production and distribution of structural steel products for building construction and residential development projects for sale. It provides and exports steel structure works for various projects. The company's services include engineering design, parts, and quality control. The company's product and services portfolio includes Fabrication and sale of structural steel of which substantial income is earned, Fabrication including installation of structural steel, and Rendering of services. The business operates in three geographical segments: Thailand, Japan, and China. Key revenue is earned from domestic sales.
68GF Score
Get the complete analysis for BKK:MCS
5-Year Yield-on-Cost % is just one metric. See GF Value™, 30-year financials, guru trades, warning signs, and more.
Quick Browse
Personalize
Premium Gurus 
Create New Portfolio
BKK:MCS has been successfully added to your 