Icape HoldingXPAR:ALICA 83 Days Payable is 144.38 as of Dec. 2025, which is 12% above its 10-year median of 129.40. GuruFocus rates XPAR:ALICA with a GF Score™ of 83/100 and a GF Value™ of €11.10 (Possible Value Trap). The stock has 5 warning signs investors should review. Among 2,440 Hardware companies, Icape Holding ranks better than 79.75% on this metric.
The historical rank and industry rank for Icape Holding's Days Payable or its related term are showing as below:
XPAR:ALICA'
s Days Payable Range Over the Past 10 Years
Min: 123.36 Med: 129.4 Max: 145.23
Current: 134.77
During the past 8 years, Icape Holding's highest Days Payable was 145.23. The lowest was 123.36. And the median was 129.40.
XPAR:ALICA's Days Payable is ranked better than 79.75% of 2440
companies
in the Hardware industry
Industry Median: 69.935
vs XPAR:ALICA: 134.77
Icape Holding's Days Payable
increased
from Dec. 2024 (141.93) to Dec. 2025 (144.38).
It may suggest that Icape Holdingdelayed paying its suppliers.
Icape Holding Days Payable Related Terms
Icape Holding Days Payable Historical Data
* Premium members only.
The historical data trend for Icape Holding's Days Payable can be seen below:
* For Operating Data section: All numbers are indicated by the unit behind each term and all currency related amount are in USD. * For other sections: All numbers are in millions except for per share data, ratio, and percentage. All currency related amount are indicated in the company's associated stock exchange currency.
XPAR:ALICA vs APH, GLW, TEL: Days Payable Comparison
For the Electronic Components subindustry, Icape Holding's Days Payable, along with its competitors' market caps and Days Payable data, can be viewed below:
* Competitive companies are chosen from companies within the same industry, with headquarter located in same country, with closest market capitalization; x-axis shows the market cap, and y-axis shows the term value; the bigger the dot, the larger the market cap. Note that "N/A" values will not show up in the chart.
Icape Holding Days Payable vs Hardware Industry
For the Hardware industry and Technology sector, Icape Holding's Days Payable distribution charts can be found below:
* The bar in red indicates where Icape Holding's Days Payable falls into.
Days Payable indicates the number of days that the account payable relative to cost of goods sold the company has. An increase of Days Payable may suggest that the company delays paying its suppliers.
Icape Holding's Days Payable for the fiscal year that ended in Dec. 2025 is calculated as
* For Operating Data section: All numbers are indicated by the unit behind each term and all currency related amount are in USD. * For other sections: All numbers are in millions except for per share data, ratio, and percentage. All currency related amount are indicated in the company's associated stock exchange currency.
Icape Holding (XPAR:ALICA) has a Days Payable of 144.38 as of Dec. 2025. Days payable represents the average amount of days a company waits to pay its invoices from suppliers. View historical data on Icape Holding and its competitors. This is 12% above median its historical median of 129.40. Over the past decade, Icape Holding's Days Payable has ranged from 123.36 to 145.23. According to the industry distribution chart, Icape Holding ranks #494 out of 2440 companies in the Hardware industry, placing it in the top 20.2%.
Is Icape Holding's Days Payable too high?
Icape Holding's current Days Payable of 144.38 is 12% above median its 10-year median of 129.40. Over the past 10 years, this metric has ranged from a low of 123.36 to a high of 145.23. The Hardware industry median Days Payable is 69.94. Icape Holding's value of 144.38 is 106.4% above this industry median. Based on the distribution chart, Icape Holding ranks #494 out of 2440 companies in the Hardware industry, which is in the top quartile — a strong position relative to peers. Overall, Icape Holding has a GF Score™ of 83/100 and is considered Possible Value Trap, reflecting its overall financial health beyond just this single metric.
How does Icape Holding's Days Payable compare to APH and GLW?
According to the Hardware industry distribution chart, Icape Holding ranks #494 out of 2440 companies for Days Payable. This places Icape Holding in the top 20% of its industry — outperforming the majority of peers. The industry median Days Payable is 69.94. Icape Holding's value of 144.38 is 106.4% above this benchmark. Historically, Icape Holding's own Days Payable has ranged from 123.36 to 145.23 over the past decade. While the company's 10-year median is 129.40 vs. the industry median of 69.94, Icape Holding has consistently been above the industry average. See the competitive comparison table and distribution chart on this page for a detailed peer-by-peer breakdown.
What is a good Days Payable for a Hardware company?
The median Days Payable among Hardware companies is 69.94, based on 2,440 companies in the industry. Companies in the top quartile (top 25%) have a Days Payable significantly above this median, while those in the bottom quartile fall well below. However, Days Payable should not be evaluated in isolation — investors should consider it alongside profitability, growth, and financial strength metrics. Icape Holding's current Days Payable of 144.38 is 106.4% above the industry median. Use the industry distribution chart on this page to see where any company falls relative to its peers.
What does a high Days Payable mean?
A high Days Payable can signal that a stock is expensive relative to its fundamentals. Days payable represents the average amount of days a company waits to pay its invoices from suppliers. View historical data on Icape Holding and its competitors. For the Hardware industry, the median Days Payable is 69.94 — values significantly above this may indicate overvaluation, while values below may suggest a bargain or underlying issues. Icape Holding's current Days Payable is 144.38, which is 12% above median its own 10-year median of 129.40. However, context matters — high-growth companies often justify higher valuations. Always evaluate alongside other metrics like GF Score™ and GF Value™.
Is Icape Holding stock overvalued right now?
Based on GuruFocus' analysis, Icape Holding (XPAR:ALICA) is currently considered Possible Value Trap. The stock's GF Value™ is €11.10, compared to a current price of €7.20 — trading 35.1% below its estimated fair value. The current Days Payable is 144.38, which is 12% above median its 10-year median of 129.40 and 106.4% above the Hardware industry median of 69.94. Icape Holding's overall GF Score™ is 83/100 with 5 warning signs to review. Investors should evaluate multiple metrics — including profitability, growth, and financial strength — before making a decision.
How is Days Payable calculated?
Days Payable is calculated from a company's financial statements. For Icape Holding (XPAR:ALICA), the current Days Payable is 144.38 as of Dec. 2025. GuruFocus calculates this using data sourced from SEC filings and annual reports. See the calculation section and 30-year financial data on this page for the full breakdown.
Is Icape Holding (XPAR:ALICA) Overvalued in 2026?
Based on GuruFocus' analysis, Icape Holding stock appears to be undervalued.
The current stock price of €7.20 is trading 35.1% below its estimated GF Value™ of €11.10.
GuruFocus considers Icape Holding to be Possible Value Trap.
Key valuation signals for XPAR:ALICA:
Days Payable: 144.38 (12% above median its 10-year median of 129.40)
GF Value™: €11.10 vs. price of €7.20 (35.1% below fair value)
Industry Position: 106.4% above the Hardware median (#494 of 2440)
No single metric tells the full story. See the XPAR:ALICA stock analysis page for a complete view including 30-year financials, guru trades, and insider activity.
Icape Holding SA is engaged in the distribution, trade, and production of printed circuit boards (PCB), which are essential components used across the electronics industry, including the business, telecommunications, automotive, connected objects, home automation, e-mobility, medical, power, multimedia, and IT industries. Its segemnts are: It operates through the Trade in printed circuit boards (PCB) - Americas; Trade and production of printed circuit boards (PCB); Trade and production of printed circuit boards (PCB) - Central Europe; Trade in printed circuit boards (PCB) - Asia and the Rest of the World, which generates maximum revenue; Trade and production of technical parts (Tech Parts) - Europe; and Trade and production of technical parts (Tech Parts) - Rest of the World.
83GF Score
Get the complete analysis for XPAR:ALICA
Days Payable is just one metric. See GF Value™, 30-year financials, guru trades, warning signs, and more.
Quick Browse
Personalize
Premium Gurus 
Create New Portfolio
XPAR:ALICA has been successfully added to your 
