* The 5-Year EBITDA Growth Rate is the 5-year average EBITDA per share growth rate. While the denominator is a percentage, we use the whole number as opposed to the decimal form for the calculation. For example, 5% would be shown as 5 as opposed to 0.05. If it's smaller than or equal to 0, then the PEG Ratio is not calculated.
The historical rank and industry rank for Dynamatic Technologies's PEG Ratio or its related term are showing as below:
NSE:DYNAMATECH'
s PEG Ratio Range Over the Past 10 Years
Min: 1.06 Med: 24.2 Max: 183.21
Current: 114.38
During the past 13 years, Dynamatic Technologies's highest PEG Ratio was 183.21. The lowest was 1.06. And the median was 24.20.
NSE:DYNAMATECH's PEG Ratio is ranked worse than 99.11% of 672
companies
in the Vehicles & Parts industry
Industry Median: 1.12
vs NSE:DYNAMATECH: 114.38
Peter Lynch thinks a company with a P/E ratio equal to its growth rate is fairly valued.
Dynamatic Technologies (NSE:DYNAMATECH) PEG Ratio Explanation
To compare stocks with different growth rates, Peter Lynch invented a ratio called PEG Ratio. PEG Ratio is defined as the P/E ratio divided by the growth ratio. He thinks a company with a P/E ratio equal to its growth rate is fairly valued. Still he said he would rather buy a company growing 20% a year with a P/E of 20, instead of a company growing 10% a year with a P/E of 10.
* For Operating Data section: All numbers are indicated by the unit behind each term and all currency related amount are in USD. * For other sections: All numbers are in millions except for per share data, ratio, and percentage. All currency related amount are indicated in the company's associated stock exchange currency.
For the Auto Parts subindustry, Dynamatic Technologies's PEG Ratio, along with its competitors' market caps and PEG Ratio data, can be viewed below:
* Competitive companies are chosen from companies within the same industry, with headquarter located in same country, with closest market capitalization; x-axis shows the market cap, and y-axis shows the term value; the bigger the dot, the larger the market cap. Note that "N/A" values will not show up in the chart.
Dynamatic Technologies PEG Ratio vs Vehicles & Parts Industry
For the Vehicles & Parts industry and Consumer Cyclical sector, Dynamatic Technologies's PEG Ratio distribution charts can be found below:
* The bar in red indicates where Dynamatic Technologies's PEG Ratio falls into.
* For Operating Data section: All numbers are indicated by the unit behind each term and all currency related amount are in USD. * For other sections: All numbers are in millions except for per share data, ratio, and percentage. All currency related amount are indicated in the company's associated stock exchange currency.
* Note: The 5-Year EBITDA Growth Rate is the 5-year average EBITDA per share growth rate. While the denominator is a percentage, we use the whole number as opposed to the decimal form for the calculation. For example, 5% would be shown as 5 as opposed to 0.05. If it's smaller than or equal to 0, then the PEG Ratio is not calculated.
Dynamatic Technologies (NSE:DYNAMATECH) has a PEG Ratio of 120.11 as of Jul. 04, 2026. Price-earnings to growth ratio is the ratio of price-earnings to a company's earnings growth rate. View historical data on Dynamatic Technologies and its competitors. This is 396% above median its historical median of 24.20. Over the past decade, Dynamatic Technologies' PEG Ratio has ranged from 1.06 to 183.21. According to the industry distribution chart, Dynamatic Technologies ranks #666 out of 672 companies in the Vehicles & Parts industry, placing it in the top 99.1%.
Is Dynamatic Technologies' PEG Ratio too high?
Dynamatic Technologies' current PEG Ratio of 120.11 is 396% above median its 10-year median of 24.20. Over the past 10 years, this metric has ranged from a low of 1.06 to a high of 183.21. The Vehicles & Parts industry median PEG Ratio is 1.12. Dynamatic Technologies' value of 120.11 is 10624.1% above this industry median. Based on the distribution chart, Dynamatic Technologies ranks #666 out of 672 companies in the Vehicles & Parts industry, which is in the bottom quartile relative to peers. Overall, Dynamatic Technologies has a GF Score™ of 65/100 and is considered Modestly Overvalued, reflecting its overall financial health beyond just this single metric.
How does Dynamatic Technologies' PEG Ratio compare to ORLY and AZO?
According to the Vehicles & Parts industry distribution chart, Dynamatic Technologies ranks #666 out of 672 companies for PEG Ratio. This places Dynamatic Technologies in the lower half of its industry. The industry median PEG Ratio is 1.12. Dynamatic Technologies' value of 120.11 is 10624.1% above this benchmark. Historically, Dynamatic Technologies' own PEG Ratio has ranged from 1.06 to 183.21 over the past decade. While the company's 10-year median is 24.20 vs. the industry median of 1.12, Dynamatic Technologies has consistently been above the industry average. See the competitive comparison table and distribution chart on this page for a detailed peer-by-peer breakdown.
What is a good PEG Ratio for a Vehicles & Parts company?
The median PEG Ratio among Vehicles & Parts companies is 1.12, based on 672 companies in the industry. Companies in the top quartile (top 25%) have a PEG Ratio significantly above this median, while those in the bottom quartile fall well below. However, PEG Ratio should not be evaluated in isolation — investors should consider it alongside profitability, growth, and financial strength metrics. Dynamatic Technologies's current PEG Ratio of 120.11 is 10624.1% above the industry median. Use the industry distribution chart on this page to see where any company falls relative to its peers.
What does a high PEG Ratio mean?
A high PEG Ratio can signal that a stock is expensive relative to its fundamentals. Price-earnings to growth ratio is the ratio of price-earnings to a company's earnings growth rate. View historical data on Dynamatic Technologies and its competitors. For the Vehicles & Parts industry, the median PEG Ratio is 1.12 — values significantly above this may indicate overvaluation, while values below may suggest a bargain or underlying issues. Dynamatic Technologies's current PEG Ratio is 120.11, which is 396% above median its own 10-year median of 24.20. However, context matters — high-growth companies often justify higher valuations. Always evaluate alongside other metrics like GF Score™ and GF Value™.
Is Dynamatic Technologies stock overvalued right now?
Based on GuruFocus' analysis, Dynamatic Technologies (NSE:DYNAMATECH) is currently considered Modestly Overvalued. The stock's GF Value™ is ₹8,460.94, compared to a current price of ₹10,288.00 — trading 21.6% above its estimated fair value. The current PEG Ratio is 120.11, which is 396% above median its 10-year median of 24.20 and 10624.1% above the Vehicles & Parts industry median of 1.12. Dynamatic Technologies' overall GF Score™ is 65/100 with 2 warning signs to review. Investors should evaluate multiple metrics — including profitability, growth, and financial strength — before making a decision.
How is PEG Ratio calculated?
PEG Ratio is calculated from a company's financial statements. For Dynamatic Technologies (NSE:DYNAMATECH), the current PEG Ratio is 120.11 as of Jul. 04, 2026. GuruFocus calculates this using data sourced from SEC filings and annual reports. See the calculation section and 30-year financial data on this page for the full breakdown.
Is Dynamatic Technologies (NSE:DYNAMATECH) Overvalued in 2026?
Based on GuruFocus' analysis, Dynamatic Technologies stock appears to be overvalued.
The current stock price of ₹10,288.00 is trading 21.6% above its estimated GF Value™ of ₹8,460.94.
GuruFocus considers Dynamatic Technologies to be Modestly Overvalued.
Key valuation signals for NSE:DYNAMATECH:
PEG Ratio: 120.11 (396% above median its 10-year median of 24.20)
GF Value™: ₹8,460.94 vs. price of ₹10,288.00 (21.6% above fair value)
Industry Position: 10624.1% above the Vehicles & Parts median (#666 of 672)
No single metric tells the full story. See the NSE:DYNAMATECH stock analysis page for a complete view including 30-year financials, guru trades, and insider activity.
Dynamatic Technologies Ltd is involved in the manufacturing of automotive components, hydraulics components, aerospace components, and wind farm power generation. The company has three main business segments: Hydraulics: Engaged in manufacturing hydraulic pumps, hand pumps, lift assemblies, valves, and power packs, Aerospace: Engaged in the manufacturing of airframe structures and precision aerospace components, Others: Includes the the Homeland division and Medical division, offering security products, and manufacturing medical kits respectively. The company earns the majority of its revenue from the Aerospace segment.
65GF Score
Get the complete analysis for NSE:DYNAMATECH
PEG Ratio is just one metric. See GF Value™, 30-year financials, guru trades, warning signs, and more.
Quick Browse
Personalize
Premium Gurus 
Create New Portfolio
NSE:DYNAMATECH has been successfully added to your 
