* The 5-Year EBITDA Growth Rate is the 5-year average EBITDA per share growth rate. While the denominator is a percentage, we use the whole number as opposed to the decimal form for the calculation. For example, 5% would be shown as 5 as opposed to 0.05. If it's smaller than or equal to 0, then the PEG Ratio is not calculated.
The historical rank and industry rank for Pan-International Industrial's PEG Ratio or its related term are showing as below:
TPE:2328'
s PEG Ratio Range Over the Past 10 Years
Min: 0.22 Med: 2.24 Max: 52.13
Current: 8.12
During the past 13 years, Pan-International Industrial's highest PEG Ratio was 52.13. The lowest was 0.22. And the median was 2.24.
TPE:2328's PEG Ratio is ranked worse than 81.68% of 857
companies
in the Hardware industry
Industry Median: 2.27
vs TPE:2328: 8.12
Peter Lynch thinks a company with a P/E ratio equal to its growth rate is fairly valued.
Pan-International Industrial (TPE:2328) PEG Ratio Explanation
To compare stocks with different growth rates, Peter Lynch invented a ratio called PEG Ratio. PEG Ratio is defined as the P/E ratio divided by the growth ratio. He thinks a company with a P/E ratio equal to its growth rate is fairly valued. Still he said he would rather buy a company growing 20% a year with a P/E of 20, instead of a company growing 10% a year with a P/E of 10.
Pan-International Industrial PEG Ratio Related Terms
Pan-International Industrial PEG Ratio Historical Data
* For Operating Data section: All numbers are indicated by the unit behind each term and all currency related amount are in USD. * For other sections: All numbers are in millions except for per share data, ratio, and percentage. All currency related amount are indicated in the company's associated stock exchange currency.
For the Electronic Components subindustry, Pan-International Industrial's PEG Ratio, along with its competitors' market caps and PEG Ratio data, can be viewed below:
* Competitive companies are chosen from companies within the same industry, with headquarter located in same country, with closest market capitalization; x-axis shows the market cap, and y-axis shows the term value; the bigger the dot, the larger the market cap. Note that "N/A" values will not show up in the chart.
Pan-International Industrial PEG Ratio vs Hardware Industry
For the Hardware industry and Technology sector, Pan-International Industrial's PEG Ratio distribution charts can be found below:
* The bar in red indicates where Pan-International Industrial's PEG Ratio falls into.
* For Operating Data section: All numbers are indicated by the unit behind each term and all currency related amount are in USD. * For other sections: All numbers are in millions except for per share data, ratio, and percentage. All currency related amount are indicated in the company's associated stock exchange currency.
* Note: The 5-Year EBITDA Growth Rate is the 5-year average EBITDA per share growth rate. While the denominator is a percentage, we use the whole number as opposed to the decimal form for the calculation. For example, 5% would be shown as 5 as opposed to 0.05. If it's smaller than or equal to 0, then the PEG Ratio is not calculated.
Pan-International Industrial (TPE:2328) has a PEG Ratio of 8.12 as of Jul. 07, 2026. Price-earnings to growth ratio is the ratio of price-earnings to a company's earnings growth rate. View historical data on Pan-International Industrial and its competitors. This is 263% above median its historical median of 2.24. Over the past decade, Pan-International Industrial's PEG Ratio has ranged from 0.22 to 52.13. According to the industry distribution chart, Pan-International Industrial ranks #700 out of 857 companies in the Hardware industry, placing it in the top 81.7%.
Is Pan-International Industrial's PEG Ratio too high?
Pan-International Industrial's current PEG Ratio of 8.12 is 263% above median its 10-year median of 2.24. Over the past 10 years, this metric has ranged from a low of 0.22 to a high of 52.13. The Hardware industry median PEG Ratio is 2.27. Pan-International Industrial's value of 8.12 is 257.7% above this industry median. Based on the distribution chart, Pan-International Industrial ranks #700 out of 857 companies in the Hardware industry, which is in the bottom quartile relative to peers. Overall, Pan-International Industrial has a GF Score™ of 78/100 and is considered Significantly Overvalued, reflecting its overall financial health beyond just this single metric.
How does Pan-International Industrial's PEG Ratio compare to APH and GLW?
According to the Hardware industry distribution chart, Pan-International Industrial ranks #700 out of 857 companies for PEG Ratio. This places Pan-International Industrial in the lower half of its industry. The industry median PEG Ratio is 2.27. Pan-International Industrial's value of 8.12 is 257.7% above this benchmark. Historically, Pan-International Industrial's own PEG Ratio has ranged from 0.22 to 52.13 over the past decade. While the company's 10-year median is 2.24 vs. the industry median of 2.27, Pan-International Industrial has consistently been above the industry average. See the competitive comparison table and distribution chart on this page for a detailed peer-by-peer breakdown.
What is a good PEG Ratio for a Hardware company?
The median PEG Ratio among Hardware companies is 2.27, based on 857 companies in the industry. Companies in the top quartile (top 25%) have a PEG Ratio significantly above this median, while those in the bottom quartile fall well below. However, PEG Ratio should not be evaluated in isolation — investors should consider it alongside profitability, growth, and financial strength metrics. Pan-International Industrial's current PEG Ratio of 8.12 is 257.7% above the industry median. Use the industry distribution chart on this page to see where any company falls relative to its peers.
What does a high PEG Ratio mean?
A high PEG Ratio can signal that a stock is expensive relative to its fundamentals. Price-earnings to growth ratio is the ratio of price-earnings to a company's earnings growth rate. View historical data on Pan-International Industrial and its competitors. For the Hardware industry, the median PEG Ratio is 2.27 — values significantly above this may indicate overvaluation, while values below may suggest a bargain or underlying issues. Pan-International Industrial's current PEG Ratio is 8.12, which is 263% above median its own 10-year median of 2.24. However, context matters — high-growth companies often justify higher valuations. Always evaluate alongside other metrics like GF Score™ and GF Value™.
Is Pan-International Industrial stock overvalued right now?
Based on GuruFocus' analysis, Pan-International Industrial (TPE:2328) is currently considered Significantly Overvalued. The stock's GF Value™ is NT$33.07, compared to a current price of NT$49.00 — trading 48.2% above its estimated fair value. The current PEG Ratio is 8.12, which is 263% above median its 10-year median of 2.24 and 257.7% above the Hardware industry median of 2.27. Pan-International Industrial's overall GF Score™ is 78/100 with 5 warning signs to review. Investors should evaluate multiple metrics — including profitability, growth, and financial strength — before making a decision.
How is PEG Ratio calculated?
PEG Ratio is calculated from a company's financial statements. For Pan-International Industrial (TPE:2328), the current PEG Ratio is 8.12 as of Jul. 07, 2026. GuruFocus calculates this using data sourced from SEC filings and annual reports. See the calculation section and 30-year financial data on this page for the full breakdown.
Is Pan-International Industrial (TPE:2328) Overvalued in 2026?
Based on GuruFocus' analysis, Pan-International Industrial stock appears to be overvalued.
The current stock price of NT$49.00 is trading 48.2% above its estimated GF Value™ of NT$33.07.
GuruFocus considers Pan-International Industrial to be Significantly Overvalued.
Key valuation signals for TPE:2328:
PEG Ratio: 8.12 (263% above median its 10-year median of 2.24)
GF Value™: NT$33.07 vs. price of NT$49.00 (48.2% above fair value)
Industry Position: 257.7% above the Hardware median (#700 of 857)
No single metric tells the full story. See the TPE:2328 stock analysis page for a complete view including 30-year financials, guru trades, and insider activity.
Pan-International Industrial Corp is engaged in the development, manufacturing, and sales of electronic signal cables, connectors, connection wires, precision molds, various plugs and sockets, telecommunication devices, wireless Bluetooth devices, printed circuit boards and other computer peripherals, medical device-related products, industrial control products, as well as automotive wire harnesses, automotive parts and accessories, and intelligent in-vehicle equipment.
78GF Score
Get the complete analysis for TPE:2328
PEG Ratio is just one metric. See GF Value™, 30-year financials, guru trades, warning signs, and more.
Quick Browse
Personalize
Premium Gurus 
Create New Portfolio
TPE:2328 has been successfully added to your 
