* The 5-Year EBITDA Growth Rate is the 5-year average EBITDA per share growth rate. While the denominator is a percentage, we use the whole number as opposed to the decimal form for the calculation. For example, 5% would be shown as 5 as opposed to 0.05. If it's smaller than or equal to 0, then the PEG Ratio is not calculated.
The historical rank and industry rank for Pantech Group Holdings Bhd's PEG Ratio or its related term are showing as below:
XKLS:5125'
s PEG Ratio Range Over the Past 10 Years
Min: 0.24 Med: 0.78 Max: 26.88
Current: 1.31
During the past 13 years, Pantech Group Holdings Bhd's highest PEG Ratio was 26.88. The lowest was 0.24. And the median was 0.78.
XKLS:5125's PEG Ratio is ranked better than 54% of 200
companies
in the Steel industry
Industry Median: 1.4
vs XKLS:5125: 1.31
Peter Lynch thinks a company with a P/E ratio equal to its growth rate is fairly valued.
Pantech Group Holdings Bhd (XKLS:5125) PEG Ratio Explanation
To compare stocks with different growth rates, Peter Lynch invented a ratio called PEG Ratio. PEG Ratio is defined as the P/E ratio divided by the growth ratio. He thinks a company with a P/E ratio equal to its growth rate is fairly valued. Still he said he would rather buy a company growing 20% a year with a P/E of 20, instead of a company growing 10% a year with a P/E of 10.
Pantech Group Holdings Bhd PEG Ratio Related Terms
Pantech Group Holdings Bhd PEG Ratio Historical Data
* For Operating Data section: All numbers are indicated by the unit behind each term and all currency related amount are in USD. * For other sections: All numbers are in millions except for per share data, ratio, and percentage. All currency related amount are indicated in the company's associated stock exchange currency.
For the Steel subindustry, Pantech Group Holdings Bhd's PEG Ratio, along with its competitors' market caps and PEG Ratio data, can be viewed below:
* Competitive companies are chosen from companies within the same industry, with headquarter located in same country, with closest market capitalization; x-axis shows the market cap, and y-axis shows the term value; the bigger the dot, the larger the market cap. Note that "N/A" values will not show up in the chart.
Pantech Group Holdings Bhd PEG Ratio vs Steel Industry
For the Steel industry and Basic Materials sector, Pantech Group Holdings Bhd's PEG Ratio distribution charts can be found below:
* The bar in red indicates where Pantech Group Holdings Bhd's PEG Ratio falls into.
* For Operating Data section: All numbers are indicated by the unit behind each term and all currency related amount are in USD. * For other sections: All numbers are in millions except for per share data, ratio, and percentage. All currency related amount are indicated in the company's associated stock exchange currency.
* Note: The 5-Year EBITDA Growth Rate is the 5-year average EBITDA per share growth rate. While the denominator is a percentage, we use the whole number as opposed to the decimal form for the calculation. For example, 5% would be shown as 5 as opposed to 0.05. If it's smaller than or equal to 0, then the PEG Ratio is not calculated.
Pantech Group Holdings Bhd (XKLS:5125) has a PEG Ratio of 1.31 as of Jul. 08, 2026. Price-earnings to growth ratio is the ratio of price-earnings to a company's earnings growth rate. View historical data on Pantech Group Holdings Bhd and its competitors. This is 68% above median its historical median of 0.78. Over the past decade, Pantech Group Holdings Bhd's PEG Ratio has ranged from 0.24 to 26.88. According to the industry distribution chart, Pantech Group Holdings Bhd ranks #92 out of 200 companies in the Steel industry, placing it in the top 46%.
Is Pantech Group Holdings Bhd's PEG Ratio too high?
Pantech Group Holdings Bhd's current PEG Ratio of 1.31 is 68% above median its 10-year median of 0.78. Over the past 10 years, this metric has ranged from a low of 0.24 to a high of 26.88. The Steel industry median PEG Ratio is 1.40. Pantech Group Holdings Bhd's value of 1.31 is 6.4% below this industry median. Based on the distribution chart, Pantech Group Holdings Bhd ranks #92 out of 200 companies in the Steel industry, which is above the industry midpoint. Overall, Pantech Group Holdings Bhd has a GF Score™ of 55/100 and is considered Modestly Undervalued, reflecting its overall financial health beyond just this single metric.
How does Pantech Group Holdings Bhd's PEG Ratio compare to NUE and STLD?
According to the Steel industry distribution chart, Pantech Group Holdings Bhd ranks #92 out of 200 companies for PEG Ratio. This puts Pantech Group Holdings Bhd in the upper half of its industry. The industry median PEG Ratio is 1.40. Pantech Group Holdings Bhd's value of 1.31 is 6.4% below this benchmark. Historically, Pantech Group Holdings Bhd's own PEG Ratio has ranged from 0.24 to 26.88 over the past decade. While the company's 10-year median is 0.78 vs. the industry median of 1.40, Pantech Group Holdings Bhd has consistently been below the industry average. See the competitive comparison table and distribution chart on this page for a detailed peer-by-peer breakdown.
What is a good PEG Ratio for a Steel company?
The median PEG Ratio among Steel companies is 1.40, based on 200 companies in the industry. Companies in the top quartile (top 25%) have a PEG Ratio significantly above this median, while those in the bottom quartile fall well below. However, PEG Ratio should not be evaluated in isolation — investors should consider it alongside profitability, growth, and financial strength metrics. Pantech Group Holdings Bhd's current PEG Ratio of 1.31 is 6.4% below the industry median. Use the industry distribution chart on this page to see where any company falls relative to its peers.
What does a high PEG Ratio mean?
A high PEG Ratio can signal that a stock is expensive relative to its fundamentals. Price-earnings to growth ratio is the ratio of price-earnings to a company's earnings growth rate. View historical data on Pantech Group Holdings Bhd and its competitors. For the Steel industry, the median PEG Ratio is 1.40 — values significantly above this may indicate overvaluation, while values below may suggest a bargain or underlying issues. Pantech Group Holdings Bhd's current PEG Ratio is 1.31, which is 68% above median its own 10-year median of 0.78. However, context matters — high-growth companies often justify higher valuations. Always evaluate alongside other metrics like GF Score™ and GF Value™.
Is Pantech Group Holdings Bhd stock overvalued right now?
Based on GuruFocus' analysis, Pantech Group Holdings Bhd (XKLS:5125) is currently considered Modestly Undervalued. The stock's GF Value™ is RM0.71, compared to a current price of RM0.64 — trading 10.6% below its estimated fair value. The current PEG Ratio is 1.31, which is 68% above median its 10-year median of 0.78 and 6.4% below the Steel industry median of 1.40. Pantech Group Holdings Bhd's overall GF Score™ is 55/100 with 3 warning signs to review. Investors should evaluate multiple metrics — including profitability, growth, and financial strength — before making a decision.
How is PEG Ratio calculated?
PEG Ratio is calculated from a company's financial statements. For Pantech Group Holdings Bhd (XKLS:5125), the current PEG Ratio is 1.31 as of Jul. 08, 2026. GuruFocus calculates this using data sourced from SEC filings and annual reports. See the calculation section and 30-year financial data on this page for the full breakdown.
Is Pantech Group Holdings Bhd (XKLS:5125) Overvalued in 2026?
Based on GuruFocus' analysis, Pantech Group Holdings Bhd stock appears to be undervalued.
The current stock price of RM0.64 is trading 10.6% below its estimated GF Value™ of RM0.71.
GuruFocus considers Pantech Group Holdings Bhd to be Modestly Undervalued.
Key valuation signals for XKLS:5125:
PEG Ratio: 1.31 (68% above median its 10-year median of 0.78)
GF Value™: RM0.71 vs. price of RM0.64 (10.6% below fair value)
Industry Position: 6.4% below the Steel median (#92 of 200)
No single metric tells the full story. See the XKLS:5125 stock analysis page for a complete view including 30-year financials, guru trades, and insider activity.
Pantech Group Holdings Bhd is engaged in investment holding and the provision of management services. The company has three operating segments: Trading, Manufacturing, and Investment holding. The company derives maximum of its revenues from the Manufacturing segment. The Trading segment is engaged in trading, supplying, and stocking high-pressure seamless and specialized steel pipes, fittings, flanges, valves, and other related products. The Manufacturing segment is engaged in the manufacturing and supply of butt-welded carbon steel fittings, stainless steel, and alloy pipes, fittings, and related products, as well as milling, machining, and welding of tube and pipe fitting. The Investment holding segment is engaged in investment holding, property investment, and management services.
55GF Score
Get the complete analysis for XKLS:5125
PEG Ratio is just one metric. See GF Value™, 30-year financials, guru trades, warning signs, and more.
Quick Browse
Personalize
Premium Gurus 
Create New Portfolio
XKLS:5125 has been successfully added to your 
